Viewing all customer Discussions for:

Other

Do you have this patio door roller?

I need this piece to repair my bi fold doors

Good Morning, In need of replacement channel balances. In speaking to customer service, it was determined that these will need to be custom. The length of the channel is 29" Width of the channel is roughly 5/8" The depth of the shoe is between 7/8" and 15/16" Stamp is 28C I will need (10) balances ... (cont.)

I have a Twinseal Single Hung P.L.# 264-019. The windowpane size is 36"H x 33"W. What balance and balance length would you recommend? And since they need to be replaced, are there other parts of the window you'd recommend replacing? Rob

Hi! I have 9 old windows (I believe they are originally from the early 1990s. That require all new channel balancers. I need to replace 18 channel balancers, but I would like to purchase 20 so I have an extra set. Provided are photos that hopefully help with identification. Note that the overal ... (cont.)

I need the striker plate for this type door handle it's an older Larson storm door with full glass Thank u

Window crank- corkscrew cartridge sheered off at tip won't connect with cogs- unable to close window ( can open) - is inner cartridge available?? ( old windows!!!) " TRUTH" made in USA

where can I find replacements or subsitutions for these.1 1/4 inch wide,1/2 inch thick,1 1/2 inch high.no idea the manufacturer. or model number

28c

Above is the window model number from tafco. Looking to replace the lock latch. It sheared in half from use and it's only 6 months old. I hope y'all can help because I can't even get tafco to use the warranty.

I have windows that have balances that are stamped 2230 but I need the stopper that keeps it in the window, they are black pieces and attached via one screw

Hi, I just bought a house and some of the windows locks are broken. Can you help me identify them so I can get some replacements? Thanks in advance!

Hello, I have two IWC sliding doors and the locking mechanism's on both stopped working almost at the same time.

Hello, looking for replacement rollers for a sliding glass door. See pictures for sizes and type.Thank you,Ryan

It is spring-loaded push it to the inside and you can pull the window open

2 screws hold it in place but the center part which the latch goes around is broken

We ordered custom balances on order #2181548 and we need an additional part

looking for this accordion part

I'm looking for replacement part numbers for both the left and right balances. The numbers I can see on the original are... E37 9#27 3-85 11600-17 Any help you can give would be greatly appreciated.

Please let me know where I can buy this replacement part and what it is. Thank You, Rebecca