Viewing all customer Discussions for:

Other

Hello need to ge these coil spring balances. Identified and possibly ordered

Please help

Do you have one of these. Thx holes about 3.78 to 4inch span. Thx

Broken and needing new on to hold the sliding tray inside cabinet of my new house

Please help identify the part I need to replace it

Hi, From the pictures you can see one window with the handle and the other window where it is missing. I am interested in locating 2 of these handles. The one I have his pretty fragile and does not open the window. These are original hardware that is 1950s. Is this hardware still available and if no ... (cont.)

Can you please help me identify which is the proper window channel balance to order (metal and plastic pieces already assembled). The metal piece measures at 27 inches. I'd appreciate it. Thank you.

This part is for an all aluminum awning window. Guessing at least 20 years old. There are no names,markings of any sort. I need 4 of them.

Door handle measurements 5.5 " outside mounting holes 1.75" inside mounting holes 6.75" x 1.5" outside measurement

This is for a bifold mirror

Looking for a tilt latch. Uniframe

Wheel mounts on bottom edge of window with a single screw. Each window gets two wheels

I need a new handle and lock (white) that has a keyed lock on outside please

Hello, I have the patio sliding door shown in the attached photos. Could you please help me identify the appropriate hardware required to install a keyed lock on the outside?

Hi. I'm looking for the truth Caradco 20755 window closer or a replacement. Thanks

looking for 2 sets of these for residential vinyl windows.

HowdyI'm looking for 2 tilt latches for a viking window, the one you have will they work, here are pics of what I needThank youGeraldine

Which one do I need? I see on the side it says 623 and then it has a number BH25

Needing help finding These windows, balance coils

Trying to identify the correct replacement snap-in glazing to match my existing windows. It was suggested they may be Jen-Weld windows, but I cannot verify that. The reveal portion appears to be 3/4" (but could be 5/8") the snap-in portion is 1/4". I need this in 72" long pieces. Thanks in adva ... (cont.)