Viewing all customer Discussions for:

Other

I am looking for a dual arm window, crank compatible to the picture shown

I am in need of this replacement. The lock part # is 9402, the keep is 9414.Thank you,Dave

guardian. Geneva ny. ansiz97.1-2009 16 CFR1201 II safety tempered SGCC22591/8ua CAN/CCSB-12.1-M. need replacement handle &lock

Hello, I am looking for replacement parts for some windows. I believe they are Anderson windows. The lock says 411099

Looking for replacement balancers for my Peachtree window. The stamp on the back of the balancer is 4248 1 BL CALDWELL.

Looked everywhere for replacement guides but unable to find.2 front bottom guides 1 3/8" wide with 2 screws and 2 rear door guides.Make is FIAT over 20 years old. Have also contacted FIAT and American Standard with no luck.

Roller has 1 1/8" metal wheel. Height is 1 3/16" Width is 11/16" I couldn't find any markings on the wheel or a manufacturer on the door itself. Thanks for the help!

I want to turn the sliding door to one that be use with key.the hold size is a 4 15/16.

Need to replace item.

Trying to locate this part for repair the outdoor awning.

It's for the opposite window. I had to force it closed because it fell off that track. I can take a better picture if need be, raining outside at the moment.

Help

I am looking for a set of replacement rollers for an 8' Tall JeldWen patio slider. The door glass code is: G505466199721 and was built in 2005.

looking for a Vetter Patio Door Hinge. See photos

after i replaced the block and tackles on my up and down window these plastic stoppers at the top of the window fell apart. window is a jordon which is probably out of production, 20 years oldjoe

I think my casement window operators are dual arm Truth entrygard in bronze color. Can you please verify before I order a lot of them? Thanks, Richard

Metal measures 27" long and just over 1/2" deep. 1" bottom plastic. Stamp is (03/8) Unique 26-0-30 and I have been unable to determine which is correct replacement. I need 2.

Hi! I'm looking for this part. It broke off my Millgard window. Do you have a replacement? This piece is 21" in length.

This is a roller for a therma thur patio French door it's a sliding screen door .The other half is broken also It's held in by two screws and the metal bends at the screws I hope all this is helpful Screen about 4 yrs old It does have a v on the metal Thanks Tim