Viewing all customer Discussions for:

Other

Its the bottom part that enables door to open and close. Any help would be appreciated. Thank you

I am looking for new wheel cartridges 4 of them these doors weight of the door is about 200 lbs it has an aluminum wedge with teeth sliding by pinion gear in wheel cartridges

26-3 stamped on side Metal channel measures 27"

We are needing window cranks, but unsure of what parts or crank handles we need

I am looking for 8109 double hung 48"X 48", Coil Balance Pivot Shoe Weather (Shield Window)

I need replacement rollers or assembly for a Pella slider screen. The assembly is attached to the frame with 3 machine screws. 36" in overall length or I'll take 2 of the 1" diameter rollers. Thanks Much, Bob

I think it T slide 1/4 drop foam filled bubble seal

Hi there, I'm looking for a more secure replacement for this locking mechanism. I saw some mortise lock replacements when seem like they would definitely be much more secure but not sure if any would fit my existing door. Would appreciate help identifying any that would work. Thanks, Sonny ... (cont.)

I've attached 3 photos; can you recommend a replacement Part, to secure our Screen (and Glass during the Winter)?

I need 4 of these: Stamp 32 5 (unsure of manufacturer) metal channel is 32.5 inches roller in bottom. See photos Also need 4 of these: Stamp is 26 4 with all the same above. Please let me know. Windows on 2nd floor almost fell out.

Looking for bubble window weather stripping. Foam core has broken down in almost all windows after 20 years. Slides into channel in window with the plastic "T" . Looks to be 5/8" wide overall. The foam cylinder portion maybe 5/16" and the overall thickness maybe 3/8". Photos attached with ruler ... (cont.)

Trying to locate T spline for storm door. Top of T is approx 1/8 and bottom 1/16 ( part that goes into slot on door frame and hold screen)

1) channel length = 30.5 inch Channel width = 0.5 inch 2) 30 3 BS1 OR (photo is attached) 3) Don't know the manufacturer 4) It is for non-tilt windows 5) Need 4 parts Thank you

Unknown shower type hanging semicircular door bottom guide. Do you have an option? THanks

At the bottom of the combination window is a little slide thing on each side corner of the bottom of the window which you push to the side to move a small post at the end of the slide which allows you to then remove the window. It is about 3 1/4 long. It is all one piece. I've bought corner pieces ... (cont.)

I need a replacement latch mechanism for my Pella storm door, registration number 90564.331691201. Can you help me? Thank you.

Hi im trying to find this part for my window this are pictures and i have find something similar but not sure will tat fit

Metal channel is 32&9/16 Stamp is 3240 Pella manufacture n/a 2 balances It also had a piece fall out. googling around it appears to be a "Stepped Sash Guide, Alpine" I checked this one against the one on your site and measurements line up. I don't however for the life of me know where it goes. I'd ... (cont.)

How to measure window to get the right balance. How long should it be . It's the 351 balances but not if length is tight

My son was mowing and ran over a rock well it flew out and hit the top window and broke only the outer pane. How do I remove the broken glass safely