Viewing all customer Discussions for:

Other

No markings present on part. Please recommend replacement

Wheel diameter 1 1/2", width is 3/8"

Hello i have an older model window and it is a block and tackle style. When i removed the old balances out to look at the size, all it says is 24 CZ. The length of the balance is 25" from the metal ends. The width was 1/2 inch. Do you have a model that's similar to that description? Let know if I ne ... (cont.)

Looking for this part

Looking for bottom track

My house was built in 2001. My full length shower door pivot pin and insert are broken (door swings open and closed). I have photos. One other vendor saw the photos and said it ismanufacture is Workwright or Workright?? Can you HELP!!! If you can not help can you recommend a supplier?THANKS (April ... (cont.)

Window world windows

Need 12 springs. 4" panels

The tilted part of the window is all vinyl weighs approximately 20 pounds. The right hand top tilt latch is damaged. The Pivot bars were both rusted out they are 3"long. The pivot shoe was measure at 2" in length,1¼"wide, and ½" thick. The spiral Balance rod was measured at 3/8wide and 34" long. It ... (cont.)

2 bottom hinges have broken off . I have attached photos of the part I am looking for. My question is Where can I get these replacement parts? Thank you Robert

I have a few charmac sliding glass doors that never stay on the tracks and grinds a lot. I would like to get a replacement rail and wheels for it. Photos attached below of the wheels currently on them.

We have a 23 year old frameless shower door. One of the brackets broke. The glass door is 1/4 inch thick and we need a replacement.

The almond one fits into a 3/8" x 3/4" frame with a 3/8" overlap. The white ones fit into a 5/16" x 3/4" frame that is 3/8" thick on the edge. We are looking for both the ones with the stop and without the stop.

I AM LOOKING TO GET 2 6400 SERIES SLIDING PATIO SCREEN DOOR GUIDES WITH SCREWS IN BEIGE. CAN YOU HELP ME OUT WITH THIS? THANK YOU.

I need 6 At twenty four inch I need eight at twenty one inch Is this possible

Hello, I have several builder-grade windows that need their window balances and connecting hardware replaced. These window balances measure 34 inches in length. Also, the spring-loaded clips that allow the window to release inwards. Any help would be appreciated.

The awning windows are installed in a home constructed in 1955. There are no patent or part numbers visible. The crank base is 6" tall, 1 3/4" deep at the base, and 1 " wide. The crank handle is 4 3/4" long. Looking to replace some missing units and need screws for others.

Hello, I need 2 jeld wen 0920 replacement balances please.

replacement outside screen need two. BRETT

The attached picture shows the type of handle I need. It is a little less than 4 inches long - I don't know the brand of window other then it is not Pella