Viewing all customer Discussions for:

Other

I have a KK Sliding Patio Door. There is a number on the sliding door - 0527990TGMC4610N (see pic #1). The locking mechanism is no longer working. I would like to replace the handles and the lock, all pieces that are shown in picture #3. I did take out the locking mechanism but could not find a part ... (cont.)

I'm looking for this top sash for my window, please help me what I have to order, one is broken. Thank you so much! Zsuzsanna Barany

I need a few pieces to help me get the windows fixed in a house we are getting ready to sell. Two sets of two springs each. Here is what I know:Set 1: 30" long with no numbers printed on or stamped into the balancing rod. They are 1/2' wide. It is from a window that is a single pane 30' by 48'. I a ... (cont.)

These vinyl tilt replacement windows were bought from Home Depot about 8-10 years ago. I couldn't figure out how to remove the tilt latches to take a photo of the inside. The window locks are 2-3/4" wide and the screw holes are aprox 2-1/8" apart.

Hi I have older Harvey windows

I need a replacement lock for my Marvin double hung window. US Patent #5-110-165

Numbers on part: 20 4 HT CMC 4 21" long metal piece, 5/8" x 1/2"

Length of metal channel is 26in and 1/2in wide. It is printed with 25-9 A05 CMC 1 on the outside of the channel. I need one replacement.

I'm looking for replacement clips for my 26+ yr old full-view storm door.Unable to find a replacement locally. Don't know the name of the door manufacturer. Offset appears to be just under 1/2 inch.

Refer to pictures for all markings and measurements. Thanks

Need to know if the part is available and if it can be replaced so I can save window.

The lock mechanism has failed. Thank you

Hi! I have a sliding Pella patio door. One of the wheels on the bottom is broke. Can I replace it? Thanks! Here's the door info: CTG Tempered 160FR 120 1ll SGCC 1804 1/8 U

Approximately 2-1/4 x 1-1/8 x 5/8

27" Series 385 Channel Balance Can you please confirm I'm looking for 16 balancers I can send more pictures Thank you Jaime

Hi, I am trying to identify this seal, can you help tell me what it is?

The inside door latch has broken off. It was installed in 1963, and we can not find any info on it.

I need to purchase two channel balances and want to make sure I order the right ones. Pictures are attached. Thank you. Susan

I have a couple units in a 1969 condo and the weatherstripping needs to be replaced. Please see the photos below and tell me if you have replacement material available

29" x 5/8"