Viewing all customer Discussions for:

Other

Do you have OEM sweep that can fit the channel on the bottom of this door?

Trying to find a replacement part for the bottom locking mechanism on my Plygem Classic Sliding Door. The part says it was manufacturer by Vanguard Plastics.

Hi - I'm looking for replacement WS. Kerf looks to be 3/8" wide so wider than normal. Hinge side strip looks to be vinyl and handle side is magnetic. Vinyl is probably cheaper but mostly concerned about the right size fin to fit into the kerf. Kerf is located on the side of the door jamb which i ... (cont.)

metal wheels, 1 inch and 1/16 diameter wheel, 3 inches long

82218 is close but note rounded face plate is 4 1/2 in length and mounting holes are 3 5/8 on center.

Hello. This (and a few identical windows in my home), will no longer stay up on their own anymore unless I prop the window up with other supports, which is annoying. I can't find any part numbers, the label shown is from the inside top of the upper window and I believe they're all original windows f ... (cont.)

Hi, I'm looking to replace the finger hold piece of this if possible, or the entire piece if necessary. Thanks in advance for your help!

have m & w window -- need pivot shoe --will buy balance as well--is their a place where i can go and pickup in my area? or person that will do job?

I would like to purchase (2) S390-16 for a 23lb window.

Not for screen door. It's for the slider glass door

Picture shows broken plastic piece on top.

Used on a patio screen door vertically as the seal when the screen door slides closed. I used a caliper to get the dimensions, so they should be close. Need about 10'. Thank you Darren

Windows are series 300 H-R50-44x72 aluminum

Good morning, I am trying to order the correct door seal for this door. Thank you Martin

I need to find a patio door handle. Thank you

Hello, can you please let me know if you have replacement parts for the 2320 1/2 inch channel balancers and related parts (top lock and bottom lock?) for these single pane double hung windows? I do not know the brand/manufacturer, only that they were new in 1975 when the house was built. The two win ... (cont.)

Hello, My window can't hold up and the Channel Balances stamp is 28 3. Can you please advise what replacement (s) part should I get? Thank you! Peggy (Irvine CA)

Help!

Need two Anderson Window sash balances. Old part number C23 6#23 10-85Dan Thank you.

Broken sash balance