Viewing all customer Discussions for:

Other

Hoping we might be able to determine the correct screen corner based off an old Harvey order we placed a few years ago. They were noted as Hollywood Corners with an identifier of 187x480. Do you have corners that would work for this? We would be looking for 200 of them. Thank you! ... (cont.)

Please identify this pivot bar. It is 1-1/2" x 1/4" with only 1 hole about 1" from one end. The window may have been underwater (salt water) during Hurricane Ike in 2008. It has not been opened since then.

I need 1/4 wide. 1 9/16 long

30 year old sliding glass door lock broken and need new handles as well. Thanks.

Looking for replacement mortice lock for Pella storm door mfg #06280290675 2046 found on door jamb. The plastic/nylon 'cap' on the catch is missing and won't retract to catch the strike plate to hold door closed. Thank you for your assistance. Fred.

Label from window and part pictured. Please send replacement partEd

Hi, looking for replacement latch for metal outer door.1" wide door3.5" mounting holes, with center spindle hole about 3/4" above lower mount.Don't need the bolt, just looking for something to latch as it shuts. Already have a deadbolt with key installed above this latch.Style not a big issue, but ... (cont.)

Pella sliding door exterior handle has a broken "screw post".

Looking for two of these.They are 30 inches long (metal part) and 1/2 inch wide (trade) widthStamped 29 6 HS CaldwellThanks!!Luis

This is a left hand sliding glass door for a client. I didn't take pics of the wheels in the frame. Each bracket has a metal two wheel system which straddles a metal center guide. Client states the metal guide got damaged and removed. Causing the sliding door to drag inside the bottom channel. We ne ... (cont.)

I placed a previous order and was successful with four of the screw mechanisms I purchased, but to were the wrong size (my fault). I need one left and one right of this size. Thank you,Kelly

Looking for replacement balancers for the product code on my Anderson double hung windows circa 1975. Code on my original is. C3 6 23 773. Any help would be appreciated. Thank you.Greg

Non tilt window, number indicated on balance: 23 3 GV CMC 7

I need to replace left side pivot pin (foot) that goes into shoe on Pella Vynal window sash. In attached picture pin appears as slightly L-shaped pointing up ward. Do carry his product? If yes, what is total cost including shipping and handling. Do you have instructions to remove and install new pin ... (cont.)

Hi, I am in need to replace the spiral balance for my windows. Please advise which spiral balance I need to order from you with the following information: Tilt window double hung Length - 35 inches Diameter- 5/8 inches Tip - it is very greasy but looks like white See attached photos. Thanks ... (cont.)

Looking for a lock set (interior latch) for this door. Has a keyed deadbolt. Registration # is 092704.90579.5581. None of the ones I've seen on your site look identical Thank you

Looking for a sasche balance for and aderson window.the house was built in 1985. Single hung window. I can see a number 11600.

The spring is 1/2" wide

Hi . My name is Tom and I'm a contractor. My client asked me to get new black hardware for his existing double sliding door (Weather shield ) brand.Style doesn't matter. Color is important.Looking at the pictures, look like striker is # 82-249Please find a rest of if plus handless. I have measuremen ... (cont.)

Hi, Could you all please help id this part. Thanks,Amy