Viewing all customer Discussions for:

39-107 Truth Hardware Operator Cover

Entry gard Truth The part I would like to replace is the bottom rusted bar that is attached to a track under the window sash. The bar is 5 inches and the track under the window sash is 7 inches. Thanks!

I need help figuring out which parts these are so I can order more.Thanks!Beth

This product was made by truth hardware I can't seem to find it on their site there was a number on the arm of the mechanism it is R30842 and I didn't seem to have any luck with that either the window is in great shape it's just the crank out pin gets stripped or chipped and even the mechanism is ... (cont.)

I'm looking for the replacement "clip" and "track" that hold the window corner in. In the attached images, the clip is out of the track and rotated 90 degrees so it is perpendicular to the track that I think it should be riding in. The crank and other levers are intact and pull the window in, but ... (cont.)

I'm looking to replace a crank on one side of the window. 34801L Either a 6 or 9 on right side.

I have 2 windows that need same part. Left and Right handle side. These windows are on the sides of my large picture window in living room.

I need to replace the entire cranking shaft.

I have a couple of casement window operators which no longer function properly. They appear to be Truth EntryGard dual arm cranks, and I found markings for 20544 and 30744 on them. Can you assist by confirming the proper replacement parts? Both left and and right hand are needed. I believe the repla ... (cont.)

We are looking for replacement parts for our crank out windows. The current parts have the name Entrygard Truth on them. One pic shows a number 31538A We would need one for left and right crank out. We will need the exterior crank out part as well as the inside cranks. Happy to send more p ... (cont.)

Hi, I can use the crank to open the window, but it doesn't close it. Thank you, Saied

window will not crank closed. Opens fine. Plastic cover piece is cracked.

Do you have 2 cranks and 6 window crank covers to fit Vetter windows?

Hi I need to replace two right hand and two left hand hinges (cranks?). Can you tell from the pictures but I need? Tom

The old handle is from an Eagle window made around April 2005. The old handle has a set screw to hold the handle in place. The set screw fits into a recess beyond the splines. The old actuator handle is 11/32", the depth of the 39-114L splines measures the same as the old handle and there is the sam ... (cont.)

Operator does not work, is this the only piece I need to replace?Left Lock

I need 5 replacements, can you help me?one with trim and handle. To be clear, the bad cranks are all on the lower right side of the window as you look at it from the inside.

I need a right hand and left hand of this item. I also own a glass and glazing company so if I I need to buy this commercially I can.

Need part for the window with following identifiers: SNE IGCC CPA

This hardware belongs to windows we bought 25 years ago. The windows were made by Pozzi who I believe sold out to Pella windows. Written on the hinge is the name "Entry Guard"I would like one of them but would purchase several to have on hand. I would really appreciate your help as the window can ... (cont.)

I need the same left window hardware. 45179, the short arm says L 31538AI'm going to need 4 replacement cranks.I need the entire hardware, not just the cranks