Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

The attached photos are the parts I need replaced but in white. Can you let me know which replacement parts I should purchase. I will need 2 of each. The crank has no. 45054 the lock has no. 30838 I look forward to hearing from you. Thanks!

Did not take out. Hope you can help from octured. 3 stories up. I tire of operator and top hinge. Yhanks

Hi, I would like to order one right and one left casement opertors. They are no name,numbers or marking.

Do you happen to sell this piece? The tip got lost, as you can see from the gray part of the handle. I would like to buy a new one.

Greetings: Need to replace opener for casement window swinging out and to the left. Please let me know if photos are not specific enough.

Hurd cranks identified by Wright 07900 - I need 2 lefts and 2 rights.

Please help me find a the hand crank and the unit it sits in. Thank you

I am looking to replace my Casement split arm operator because mine is broken. It is a Original crank and casement?I am not sure if it is the same as the Product Code: 39-315 because mine has 5.5 inch (As the picture) and the 39-315 has 5 inch

Need replacement casement window cranks. House built 1955Found Detroit written on crank

Hi! Desperate to replace the crank on awning window(s) and prefer to not use them at all....remodeling now and contractor wants a low profile closure...will never open these windows up. Help...any ideas?

We need a crank bent arm that needs to be 3" rather than the 5" we purchased. Do you sell such an item? White or the rust/ copper color can work. Thanks for your help

Bad hardware on a vinyl casement

i have a stripped hand crank for a casement window. s swear it says "TRUTH" on the 9 inch handle. one difference i noticed is that there are no screws on the inside of the window to hold the crank in place, it is screwed in from outside toward the room. there photos look very similar but not perfe ... (cont.)

I believe I need Left but not sure of the part number...

I would like to replace all parts but want to make sure I have the right ones thanks for your help Clay

Need replacement hand cranks for our casement windows.

Hurd awning windows. Closure is worn. Hopefully can replace. Thanks Steve

I am hoping you can help me identify the operator pictured here. We took some measurements. The arms were each 12" long when fully extended from the gear to the tip of the arm, not including the brass hardware at the end of each arm. And a total of 25.5" spread when open. The two arms had part nu ... (cont.)

Hi, I have a Shucco casement window installed in 2004. The crank has come out. Any idea what I need to replace it with? The window itself is fine. I can insert the handle/crank back in the hole and turn it to open it, but it doesn't go all the way back in and I can't close it. And of co ... (cont.)

Please see the photos, this is identical to the one that is stripped, the one that's broken is on the right side when you're looking at the window from outside ? so it is opposite. This one was just easier to photograph because of the lighting. This is on a rental property I have and I couldn't fin ... (cont.)