Viewing all customer Discussions for:

39-143 12" Awning Operator, Single Pull

No markings. The arms are manufactured bent similar to 39-393. Extended out the arms total about 12"

I am looking for a window operator replacement with the same dimensions for re-installation.

Manufacturer: Truth

BIU

I need a replacement window operator for this Hurd window. The current one is stripped out. The crank will open the windows but you have to press on it from outside the house to close. I can fix about anything with a good YouTube video to follow.

Does anyone know what model this might be. I found similar ones but theyre not the same color/material but they do look similar. Thank you.

The windows are about 30 yrs old . Windows are fine but won't crank out anymore. Hardware is too rusted to see any markings.

I have three of these crank windows with the hardware all rusted out (the home is right along the salty ocean). I believe I need the 16 inch dual arm crank to replace the hardware, but I also need to know what other parts I need to attach to the underside of the window itself. The part is so rusted ... (cont.)

Legs are 12" long by 4" w handle 5" wide center swing

21.75" awning window. Truth hardware. Rotator at operator needs replacing. In an older weather shield window.

Is it possible to get the 39-143 awning operator in the color black?

Hi, I'm looking for Truth Awning Operator 30896 substitute. Thanks

This is a 25 yr old Caradco window. Abt 18x18. The crank has pushed out of the housing. The arms go to the left and right. I need a replacement.

Looking for hardware for two different windows. Please reference the photos and the file names as I've labeled them "Window 1 and Window 2" replacement Window 1 has a 3329 on the bottom plate. thanks!

Any guess as to what this crank is? Window is approx 2' x 2'.

The window opens along the bottom. Any other info (like measurements) I could send to you?

Hope you can help. No photo of this installed as I had already removed it.

The photos above show the "ring nut" that does not stay in place when I crank the window closed. The crank "driver" mechanism (photo 1) is held in place using this "ring nut" screwed securely into the crank fitting (photo 5) to hold it snuggly in place (photo 4). Since the ring nut is old and threa ... (cont.)

Operator is stripped It measures 5" inside

Hello, I'm looking for help identifying this. It's about 10-11 inches fully extended. Do you have this part?