Viewing all customer Discussions for:

39-277 LH Awning Operator, Nu-Aire

Looking for replacement window cranks for 1970 building. No markings, nothing on the cranks.

Hello, can you please help me identify this and do you have a replacement one please? Thank you.

I need to replace it. I'm clueless about measurements, etc. I had ordered a replacement from Amazon, but when it got here I noticed that it had two holes at the top of it and the one in the picture only has one hole at the top. I had to return it. I'm asking my son to install it since I am in my ... (cont.)

No mfg. Or writing cept 14 3691*1

Hello!I have 13 right and 2 left operators I would like to replace in a home in southwest Florida. The patent number D 198202 was found embossed in the metal cover. Could you please identify these parts for me so I may completely replace all?Thanks for your support,Wayne.

The dangle linkage is 2 3/4" on centers. Looking for new replacement

I have a couple that are broken and need to be replaced.

Hi there, I have no idea what type of windows I have and what type of replacement crank to buy (I need 2). I hope you can help! Thank you! Callie

My crank windows are on the porch of a 1960's modern ranch home.1

No markings present on part. Please recommend replacement

Marking inside housing are PAT. No. 198 202 U.8 - ?8 a bit worn; 2 R.H. RD1963 CA There is also a square with diagonal lines from each corner with .06 stamped in the center. This is on the inside of the top corner of the housing. Dimensions Operator link holes are 2 3/4" apart. Has Nylon bushing ... (cont.)

There are no names or part numbers on the existing crank. I ordered 39-060, the Keller window crank, hoping it was the right part. It is not. The case appears the same, but the arm is shorter on this one (~5cm) and the hole that attaches to the window arm is wider in diameter (~1cm). Serves me r ... (cont.)

Attached are pictures and dimensions of a window crank operator that I believe is or close to the 39 - 084, but there are some slight differences. The 2 holes at the bottom measure a center to center spacing of 1-3/16" whereas the dimension you show is 1-1/8". The arm extension has a clearan ... (cont.)

I need 5 of therse window cranks IH CO 790.

Hi, The crank on my window shutter is broken. In the pictures attached, the part that I use to the close the window (crank) is separated from the body and won't latch on. The crank was able to open the window further but not close it. I had to put bricks on my blinds to keep them closed ... (cont.)

This is from a house that was build in 1925. The arm that comes out of the box does not protrude out of the box when fully close which makes it difficult to identify the correct window operator. From what I could measure, the arm that is connected by the screw is about 2 3/8 in length.The space betw ... (cont.)

I am trying to find out what operator could be used to replace the ones I have depicted in the figure and photos attached. Also can handles be purchased independently. My guess is these windows were original with the house from around the 1960's in north Florida.

The mount on the crank housing broke and the worm gear that attaches to the handle came out. I jerry-rigged it and got it to close. Is a replacement available? I'll need a right and a left (so they match. Thanks.

Hi. This is the type of Awning Window operator I need (this is a different window but the other is also "right side" and suffered from the same corrosion but broke)I am in Hawaii. Thanks!

Please identify this part and I will buy a new one to replace it. Please let me know if you need more information