Viewing all customer Discussions for:

58-156 3/16" x 3/8" Foam Filled Bubble Seal, 12ft

I'm going to assume that I need Part# 55-174. Of the three windows two are fixed in place with no way to remove the old brittle glazing without digging it out in pieces. Am I correct? If so do I just press the new glazing in the gap?

Good morning, I have two Peachtree entry doors (79" x 30") to my garage. They were installed in 1990 when the house was built. Really need to replace the weather stripping but have not been able to find any product that fits. Have attachedimage003.jpg a picture of the original stripping. Hope you c ... (cont.)

31x77inch ancient sliding wood patio doors. There are eight doors in total or four pairs.

Picture one is rubber glazing. 5/8 and it snaps in. Picture two is weather seal that goes all the way around the window casement. These windows look a lot like Andersen windows, now markings at all, they were installed in 1994 in an indoor excise pool room.

I have 5 (five) 40" double hung (double tilt in) windows. We installed them new in late 90's, we think. The bottom sash on one window has a bubble seal on it. As near as I can figure, it is 58-156 for replacement. However, the other 4 windows do not have the side opening where you would slide the pa ... (cont.)

Please see pictures. One hollow bubble type, and one foam filled.

Installed many Simonton Windows over the years and customers are calling me because of failed Weather Stripping. Can you help? thanks,

Good evening,We are desperately trying to find this weather stripping. The brand of window was a Phillips. That has since been discontinued. Thank you so much for any helpSincerelyDavid

See pictures attached

Anderson Sash 11600-17: Number appears to be "623 2 RH75 0294" OR "623 2 BH75 0294". When inside of room this goes on right hand side. (Does your part fit LEFT and RIGHT? ...in case other side breaks)

I have vinyl windows with 3/16" t-slot on the bottom. Will this fit into a 3/16" t-slot?

Hello, I've looked all over the window, window hardware, window glass, etc but can't find any information on the manufacturer or part number. When we moved into the house a month ago I noticed the windows don't close all the way so the locking mechanism is not working properly. When I looked that ... (cont.)

Hi, I'm wondering if you have something to replace the weather stripping in the photos. The foot is 3/16" wide. It is about 3/16" tall overall. The bulb part is about 0.09" wide at the base. It widens out to about 1/8" at the top. The weather stripping fits into a grove that surrounds the out ... (cont.)