Viewing all customer Discussions for:

81-004 Patio Door Roller, 1-1/2" Steel Ball Bearing

Hello! May I get some assistance with locating the replacement for this sliding door roller? I can send additional measurements or pictures if needed. Thank you!

Looking for 2 replacement wheels for a sliding glass door

No identifying letters or numbers on the roller.

Can you help me what kind of rollers I need in the pictures!

Lable on door etl sponsored Spec: sgd-r20 Series:3000/3100 Code: 92-2 Mat 12068 (0x0)

I'm needing some parts for my sliding glass door. Pictures attached. Thanks , Matt

I'm needing new rollers I took apart door and removed 1 rollers hoping both are the same. This is for a sliding glass door. Roller size appears to 1 1/4".

no part number or mfg labeling that we can see

I'm tring to find the correct part to fit a sliding door from around 1979. Our home was built in 1979 and the door(s) are original to the home. The only sticker I can find on the doors says, "General Aluminum Products, Charlotte, NC," and "Care Free Products." I would like replace the rollers i ... (cont.)

trying to locate these rollers

Hi I have a 1986 aluminum sliding glass door and the roller broke out of one side both sides are the same part I don't see any numbers or identification on the housing. Please advise if you know what this part is and if you carry it. Thank you so much!

Hi. We removed these off of our sliding glass door and are looking for replacements. Also, do you sell the piece that goes over the top of the rail the wheels go on? Do we have even need that if we replace the wheels? I went ahead and ordered 81-004 from you with express shipping as our door is a ... (cont.)

No markings on the roller. 1.5" metal roller, 2-1/4" long from wheel edge to outside of screw housing, 1-5/16" tall, 7/16" wide (~5/8" with roller stem)

I'm having problems finding the adjusting screws on my plate glass (1967) slider. There are no visable adjusting screws or plugs. All other windows are Wayfair aluminum frames, the slider is unmarked. The door operates with ease, (a rail cap has been installed) but does not line up with the jamb. I ... (cont.)

Looks exactly like the 81-004 but that one has an inch and a half roller mine has an inch and a quarter roller

I need an entire roller for a sliding glass good. It's an older door and am not able to find parts locally . I need two in order to balance the sliding glass door

I need 2 rollers for my old aluminum patio door. Please help me find the correct replacement

Hi There, I'm trying to find replacement rollers for a sliding door. The only description I can give you about the door is, it is original to the house that was built in 1986. It is aluminum. The dimensions are as follows, length 2-1/4", width 1-5/16th", Thickness 7/16ths" and the roller diameter is ... (cont.)

On the Side of the roller are the words:P E Del MarMADE IN U.S.A.Sizes are also in the fourth photo.Wheel is metal (1 1/4")Height (1 5/16")Length (2 7/8")Width (3/4")

Trying to find sliding glass door roller