Viewing all customer Discussions for:

81-007 Sliding Door Roller, Remington

The sliding glass door is in the back, glass-enclosed poarch that was built in the early to mid 1960s. The parts of the front roller have no discernible names, numbers or markings on them.

Number 138 on part.Don't know door manufacturer.The top of the wheel assembly slides into the frame and a screw holds it in place.dimensions are 1" high 5/8" wide 2 and 3/16 long wheel is 1 1/8 inch

Can you help me get the right parts?

Housing width: 3/4" Housing length: 2 5/8" Housing height: 1" Wheel diameter: 1 1/8" Thank you for your assistance wirh this request.

Need new rollers

8 on one side 123 on the other. 1 1/2" single wheel.

Sliding door rollers

Metal roller on one side number 8 is written and 123 on the other.

Im not sure if I ordered the correct wheel assembly. Can you identify this old slide door wheel? 1 in steel wheel. I ordered p/n 81-011 but not sure. .CHUCK

I have a patio door that was probably installed in 1978 and the rollers are not rolling anymore. I have removed one of the rollers and attached a photo of same. It is 15/16 tall, 1/2 thick, and 1 3/4 long. Concave wheel is one inch diameter.

The door is about 20 years old with no markings of the manufacturer. It is a steel roller with a steel concave wheel 1 1/4', 1/2" width and 1" high. The wheel cannot be adjusted up or down. It appears that the bearings are worn. And the whole thing is rusted. I would like to replace this roller (fro ... (cont.)

Rollers and bottom weatherstrip for 1986 era Old Castle patio doors. Rollers have metal wheel, 1 1/8" diameter. Housing is 2 11/32" long and 19/32" wide and 1 1/16" tall. Weatherstrip (one each side on bottom door frame is 46 1/4" long and has 9/32" wide plastic strip to slide into rail. Unable to ... (cont.)

This is a door I'm trying to save the owner is selling the house. The wheel is inch and an eighth The body holding the wheel is one inch high and 2 and a quarter wide

Can't find much info on the door and the number on the roller hardware yields no search results.

Can you help me select replacement part. If something of better is available that good Thanks Carmen

Hi. I need two patio door rollers. It's about 2" long x 1" high x 3/8" thick. The wheel is about 1 1/8" across. It had a single screw in the side (not shown in photos) that adjusted the wheel up and down. Thanks in advance for your help. Regards, Ron

I would really appreciate any help you can give to identify (Part No) of this roller assembly so that I can order! Case/Assy Length 2 1/4" Height 1" case Width 1/2" Ttl Width (w tabs) 3/4" Roller Diameter 1 1/16" to 1 1/8 Approx Width 1/4" to 9/32 Approx

Hello, It has the number 123 stamped on the side. It's 1 1/4 inches long, 1 5/8 inches wide, 1 1/8 tall, has 1 1/4 metal wheel. 2 holes in the face spaced 1 9/16 inches apart and the top one is threaded

Looking to replace this roller as it no longer holds the wheel.

The house is built 1980's .. I couldn't find any number, name, or marking.