Viewing all customer Discussions for:

81-030 Acorn Patio Sliding Glass Door Roller, 1-1/4"

measurements are so close but neither has the angle at the wheel like the original but I'm not sure if that matters. Can you tell me if your 81-138 or 81-030 would be the closest replacement, please?

Hello, I have rollers that are exactly like your 81-030 units, but have 1" wheels vs. your 1-1/4" wheels. Do you think your units will work for me, or do you have these with 1" wheels? Thanks!

Door is only couple years old. Rollers already bad. S1000 performer HP door. I don't have any other information.

I need replacement sliders for a Reliabilt 4444467 from lowes. I think the 81-030 might be it. I just bought the door but these already appear to be a consumable component. I wonder do the mounting screws shown 33-097 attach these rollers?

Hi, hope you can help me. Have Stanley patio doors and need wheel assemblies. Housing is brass and wheels are plastic. Am hoping I can find steel rollers with ball bearings. This is the 2nd time I have to replace these in just a couple of years. Overall length is 4 1/4" from end of housing to edge o ... (cont.)

thanks

Product of Del Mar Eng Co Long Beach, CAL Need 2 for this door

Hello. I need to replace the lock and rollers on my sliding glass door. I need some help identifying the replacement parts. Thanks for the help.

Hello I'm looking for these patio door rollers. Do you have anything available? They are about 5/8 wide 3" long Wheels are 1 1/2 tall

Hi Folks, the existing rollers measure .750 X 3.075 and have 1.250 Dia rollers. I did order the Swisco part # 81-138. They do not fit into the channel, the rivit hinge is wader then .750. I would like to return those for the correct ones. The original rollers have a partially raised frame where the ... (cont.)

2 rollers has a "V" stamped on it

I need 2, possibly 4 of these pieces. Please help!!! I have been looking for these for over 2 years.Carlos

Greetings! I have a Phillips Products Series 870 Sliding Glass Door, CCMC#12765-L, and need to replace the rollers. My web searches have led me here. Any ideas? I haven?t taken the door off yet to get any pictures. I have added a picture of the sticker inside the door. Thanks! Paul ... (cont.)

Patio Door Rollers for SuperSeal 800 series Patio door...don't know dimensions until I take the door off.

Couldn't see any markings

Hi, I ordered part #81-138 from you back in March. I just got around to trying to replace my Milgard door's rollers and when I removed the old tandem roller, I found that the wheels were larger than those on #81-138. Could the 81-030 possibly work on a Milgard door?

Front and side edge of two parts. Can you identify?In the last photo is a roller. I took these out yesterday to photograph them. Didn't think to measure. Can you identify them from the pictures or do I have to take them out again to measure?

Rollers forsgdr35 71×80

I need to replace the rollers on my sliding door. This door was the original that came with the house built in 1970. It has a sliding door and stationary door. Total width is 6', sliding door is 3'. I can't find anything on the door itself that identifies a part number. The door handle has the c ... (cont.)

It is just like the Acorn Patio Sliding Glass Door RollerProduct Code: 81-030Only I need the rollers to be 1 1/8" not 1 1/4"I will probably order two.