Viewing all customer Discussions for:

81-128 Andersen Sliding Glass Door Roller

Please see the attached photos. I think I need the rollers for an older Andersen sliding door. Can you please confirm the appropriate part number?

Metal rollers, two per door, need four total wheel diameter 1 5/16 inches markings on wheel housing: Right side: 7163HD-5 Left side: 2

I believe there milgaurd doors.

Do you have these patio door rollers?

Approx 20 years old or more.

Need to replace. Had to open and close doot

Very hard to roll open and close,,sliding very heavy like

7116-5 F patented 1967 CAN PAT NO 3,237,238

I need a set of rollers for a PS11 6L sliding door. The number on the roller assembly is 7116-5. There is also a B stamped on it. The total length including rollers is 4 1/8", distance between rollers pin to pin is 2 7/8", frame length excluding rollers is 3 3/8", roller diameter is 1 1/4", frame he ... (cont.)

It appears we have some Anderson 200 Series Perma-Shield (Maybe?) sliding doors in need of roller replacements. Of the three sets, one is nearly immobile and the other two are nearing similar conditions. We had planned to remove the units from the tracks to replace the rollers soon, but thought it ... (cont.)

7116-5

The number on it says 7116-5. There's an F on the side. Also says patented1967 Can. Pat no. 3,237,238 I need 8 of these rollers.

Installed in 1978

I need to of these rollers i dont see anymore stamps or id marking except (T 163-5). Its for a sliding patio door. If possible i would like to know any iformation you can obtain from these pics. Thanks,

Hoping to figure out what part I need - the older one here is shot (number on it looks like 7116-5)I bought two of these new ones and are just a hair too wide to get back in the door. Any ideas on what part will work? Thanks so much in advance!Chris

Looking for a pair of Anderson patio sliding doors rollers there is a #on them #7163-2 thanks ken

I received a replacement roller from you last week. It was order #2337837 and included part number 81-018. It is not a match to the TRUTH roller. It is close, but the tabs to attach it to the door are flush with the assembly, while the Truth assembly tabs are lowered from the assembly. The ones I re ... (cont.)

I purchased replacement rollers from Amazon which appear to be an exact fit. They fit just like the original rollers in the door bottom but I cannot get the door over the jam and on the track. With the wheels turned all the way in, I tried lifting with a small crow bar and cannot get it over the flo ... (cont.)

Hello, I do not know the manufacturer of the sliding glass door. The door has two holes in the front and no screws in the sides for adjustment. So, I think it uses one of the tandem roller designs that you have. I think it is one of the following: 81-018, 81-128, 81-141, 81-149, 81-182, 81-188. A ... (cont.)

Hi. I have a client that needs the two double wheel carriage rollers on the bottom. The bearing have locked up and are not rolling. This is a 6ft wide door. Thanks!