Viewing all customer Discussions for:

81-129 Diecast Roller, 1-1/2" wheel

Hi, I've been trying to find replacement rollers for my sliding door (see attached). Also need to replace the worn track. Thanks, Steve LeSage

Liking to replace rollers on a sliding patio doors. What would be the correct rollers for this application? Thank you.

Lookimg for a replacement.

I don't know what my part is. Thank you for your help and time. I really appreciate it. Photos included.

It looks like it should be 81–129 It is three-quarter inch thick frame, one and a half inch roller

I need two roller units. This also holds together glass frame.

I'm trying to replace rollers for this door, see the pictures for references, the outer housing seems to still be in the door, its stuck in the slide in rail, likely by a screw from the top but the rail was stuck and we coudldn't remove it, it also had a screw to the door frame above the adjustment ... (cont.)

Piece attached to door not shown in picture that wheel assembly goes into.

Set of rollers for patio door

These wheels cant be adjusted anymore and need to be replaced. The number I could find on theseis 6572. The marking on the glas is the following: pPG Herculite K, ANSI-Z-97 1-1972 3/16" U Temp safety Glass SGCC - 02 11372

Roller wheels for a mobile home sliding glass door

ROLLER WHEEL DIAMETER IS 1 AND A HALF INCHES. WIDTH OF HOUSING IS 20MM (THREE QUARTERS OF AN INCH). HEIGHT OF HOUSING IS 1 AND A QUARTER INCH APPROX. LENGTH OF ROLLER END TO END IS 3 INCHES.

The wheel went bad. The body is ok. On the wheel it says S&S VB-38

Note "A-3" on one side and A-5" on the other. I need 4 if you can find

This old part is L-3 inches long, W-3/4, H-1 1/8. Wheel is 1 1/2 diameter. No part number. The area inside the door space. From bottom of door up to glass = H-1 1/2 inches, this is open space to the other end of the door. Inside diameter

Good morning! I'm Zach and I've got a house built in 1964 with original doors. I've uploaded the exact rollers I'm looking for. Is this something you've seen before? Thank you and please let me know if you have any questions. Zach

Hello, We've just recently purchased a home that was built in the early 70's. One of our sliding doors is difficult to move, and when I checked the roller assembly's, it appears that one of them is broken, and the other one has had is threads stripped from an attempted adjustment. There are no ... (cont.)

Snapped and we need to replace

Sliding glass patio door dates to 1966. Original rollers are all-steel and door weighs at least about 100lbs. Wheel outer diameter = 1.25" Wheel thickness = 0.3" Wheel bearing diameter = 0.6" Frame width appears to be 3/4" to 7/8" (not directly measured - see photo 05) Vertical distance from mounti ... (cont.)

I am trying to find a replacement for what looks to be a Kilian branded patio door rollerI believe the bracket is about 3/4" wideThe wheels are about 1.25" in diameter and about 5/16" wideAlso, there is a screw that threads in at the top