Viewing all customer Discussions for:

82-013 Sliding Door Handle Set, 3" Hole Centers

Hi, I want to see if you have the door handle for this. Thanks

Hi! I have an old door handle and latch lock that needs to be replaced. Below are pictures. It has two 3-inch centered holes and there is a hinge mechanism on top of the handle that slides over a latch which is attached to the outer edge of the steel door frame. The house was built in 1950. The new ... (cont.)

Hi, I have a very large sliding glass door with this handle on it. I am guessing handle is from 1960's. It has a lucite handle, which has broken at the mounts. Cast in the lock level is "Ador" and no other part/identifying numbers. I would like to either find a replacement lucite handle (could ... (cont.)

All I really need is the little "pot metal" hook which the tip is broken off. However I would be happy to purchase a new lock. I really don't care about the style (my other door has a lucite pull) I just want one that fits. Latch and handle instal on inside and outside of door NOT within the doo ... (cont.)

I'm looking to find a new handle and lock that would work for this. I can't find anything relative online and I've never something this old fashioned. Any ideas would be appreciated. Thanks.

I'm looking for a replacement for our sliding patio door handle...the holes in the sliding door handle measure 3 15/16" apart... We would prefer the same color combination if possible. If there isn't a replacement with a locking mechanism we're fine with just a pull handle.

your 82-013, does it come without a lock and cosmetically nice.

The inside door latch has broken off. It was installed in 1963, and we can not find any info on it.

What metal is used in 82-013? Zinc, steel, aluminum or another alloy?

When it was assembled I think it looked very much like the second picture, which I have uploaded from your website. Please let me know ASAP what I can buy to repair or replace this lock.

My patio door is an old one. I'm guessing from the 1960s. The screw spacing is 3 inches OC and the latch is surface mounted not in the door itself. I couldn't find any brand or numbers.

Hi Folk, I'm looking for something like your SURFACE MOUNT HANDLE SET, 3-1/2", Product Code: 82-016, except mine seems to have 3" installation holes, not 3-1/2". I'm not concerned about the style; I just want it to fit. It looks intact in these pictures but the metal part of the handle broke and it ... (cont.)

I am trying to confirm the correct door handle set to order to replace on a sliding glass door. Attached are the pictures. Yup, she was an oldie but goodie. Thank you

The handles are original from a house built in 1960. The first picture is of the handle with a broken latch. The second is the only identifying marking on the handle. The third is the piece that the latch hooks into. The last picture shows the unbroken handle on another sliding door. The hole spacin ... (cont.)

Do you carry this handle? This door is old but still works great other than this.

Here are some pics from a sliding patio door at Yorktowne Square Condominiums in Falls Church, VA This is original equipment, circa 1969. Handle is ok on the inside but the locking lever just spins freely. The lock mechanism is on the inside of the frame with limited access. It appears that whatever ... (cont.)

Hi we are trying to replace this pod door handle. You can see that the hook is flush with the backside of the metal plate that attaches to the door. Mostly every replacement off the shelf handle will have the hook in the middle which puts the hook out of alignment with the existing Female portion of ... (cont.)

Trying to locate a new handle and hardware like this hope you can help.

Attachment holes are 3 15/16 inches

No markings. Holes are 3 inches apart, 4 3/4 height