Viewing all customer Discussions for:

84-001 Spring Tension Screen Door Roller

Looking for the correct replacement rollers for my screen door

I need to replace my screen door rollers again (5 years) due to rust from living near the Gulf. The roller type is the M spring type 84-001, or 84-031, or 84-007. The screws used for tension are also rusted. Is there a roller and screw that you could recommend that may not be subject to quick rustin ... (cont.)

Screen Door Rollers 1" diameter x 1/4" wide. Can't figure out how to remove it. I've tried backing adjusting screw out, screwing adjusting screw in and unit won't budge. It doesn't appear to be the type that clips on to pins in the aperture. No apparent markings

The nylon blind nut for the adjustment screw is stripped and I'm not sure if it can accommodate a larger screw since it is very brittle. Can I replace this part? If not, what are my options? Will an 84-074 fit in the same cavity as my current assembly? Thanks in advance, Robert.

Upper plastic rollers shot on screen door from the 60's how do I remove and replace?

Looking to replace these wheels (4 each) on two sliding screen doors -- 8 total. Can you please provide part number? Thank you.

Ineed 24 of these

Peach Tree screen door about 20 years old. Need 4 new rollers

The first two photos are of the top of the door, the 3rd and 4th are of the bottom. The bottom 3rd pic does not rotate, the 4th does turn but does not protrude below the door. The top rollers are fine. But there is no screw holding them in place. They seem to be in a slot in the frame. I don't ... (cont.)

Can not find correct roller for my 1900 series patio door screen. Please help

Please advise with parts number, I need 4 screen door rollers w/ spring

I don't see any markings on the screen door. I can send photos of the French door if you need. There is an adjustment screw on the side, but removing it doesn't loosen the roller. I have seen YouTube videos where you can pry the roller off the retaining clip, but this roller is spot welded to the ... (cont.)

Best I can door for these parts to the screen door. If you have the parts will order.Mike

Been in the business for 18 years and have never seen a roller like this

Need help with part number please. Thanks.

Can you help identify this roller? The tension bar is 5/16" wide and about 4" long, the wheel is 1" diam.

Patent No. 3090084 It took me some time to pry this one out, and am not looking forward to wrestling the other 7. (4 each, two top, two bottom, on two balcony sliding screen doors.) I've indicated "Quick learner" as there is no "All Thumbs" choice. Regards, Martin

Where can I find a replacement for this?

I though they might be 84-001 The house was built in 1986. They could be the original parts

I need theses parts, four each