Viewing all customer Discussions for:

84-095 Moss Patio Door Roller

Hello, do you have a roller like the one indicated in the pictures? It's for a screen door and the rollers go at the bottom of the door. It comes both with a nylon wheel or a metal wheel.

Looking for replacement

Hi I have searched all of my local hardware stores, Swisco, and other online sources, and cannot find any rollers that look similar to mine. I had a difficult time removing them, and cannot tell exactly how they were held in place. But. there are two funny little "spikes" on either side of the rol ... (cont.)

Hello!I need the replacement part for the rollers on my screen door. Could you please tell me what the part number is and where I can buy this part?Thank you!AnnMarie

Hello Swisco, this is from a Novatech sliding screen door, have not been able to find a match anywhere. Any ideas? The photo showing 0.57" caliper is the center-to-center for the two mounting holes. The roller wheel is 1" diameter and 0.23" OD. I think the bearing is pretty gummed up. Thanks! ... (cont.)

Looking to replace screen door rollers as some of them have failed

I haven't been able to find the correct replacement parts for our screen door , I hope you can help.Thanks, Bob

I ordered and received 84-007. They are just a bit too thick for my application, so that they will not slide into the door frame. That attached pictures give a pretty good comparison. My measured thickness is about 9/32" to 5/16". My rollers are 15/16" to 1" o.d.What item number do you recommend?May ... (cont.)

I need 2 replacement parts ... new rollers for a patio screen door. Attached are 2 photos of the broken rollers... one open and one closed Also attached is a traced on schematic that shows actual dimensions. One dimension not shown is this: the metal part is 1/4 inch thick. I will be driving thru ... (cont.)

The screen door is old but I just re-screened so it looks new. The 2 spring loaded wheels along the bottom are broken off so they won't roll making the screen impossible to move without dragging it. I am trying to find 2 replacement wheels for the bottom. The top wheels are still good. ... (cont.)

I'm in need of some new adjustment rollers

i ordered part #84-050 and 84-050N but the side with the screw on it that attaches to the frame of the door is too wide. the one in the pictures is what i need. that is the last original roller that i have and i am going to need a large quantity when i find the proper size. The plastic roller on th ... (cont.)

The rollers are attached on the corner ends of the patio screen door. Remove the screw that attaches the wheel housing and install the new with the existing screw. The screw that comes with this roller is the adjusting screw; the adjusting screw will raise and lower the wheel inside the roller hou ... (cont.)

Fits standard size Simonton French door. Very similar to your 84-050N but dimensions are different. Any help?

Would the Moss Patio Door Roller 84-095 work as a replacement?

I need help identifying this part.

Can you tell me where I can buy two of these rollers? Thanks so much.

I wanted to replace the worn roller for my 2 screen doors but could not find it anywhere. It is a steel ball bearing 13/16" in diameter roller. I bought one from your Company item #84-095 four years ago, and it does not fit in the slot (hope I could return it). I put it aside and wanted to fix the s ... (cont.)

Patio door roller

Do you think I would be better off with the moss roller or the pacesetter (84-050). The width of the current roller is 3/8in. The moss roller seems to be a bit narrower than the pacesetter. The overall width of the bottom of the door is 5/8 in but the frame thickness would make a 1/2 roller a ti ... (cont.)