Viewing all customer Discussions for:

87-132 Sliding Window Glide Button

This white plastic sliding window anti lift 3/4 inch long plastic block prevents the from raising up and jumping out of the track. Can you identify and provide. The plug portion broke off. It plugs into a hole in the channel. Thank you for your assistance in finding this part.

Is there such a thing as a plug to put at the bottom of my outside door where my pile weather stripping slides into so that it doesn't drop to the bottom and drag? Right now I tapped it but was wondering if there was another solution?

Hello I need this circle part for my window.

Hi, We have a sunroom circa 2010 installation and cannot pull a part number from the window. Hard to see in the background, but it's a split slider with screens. Picture #1 shows it installed (just a press-in), on both top and bottom of glass frame. Other pictures I hope help with dimensions. I ... (cont.)

Ther is a #271 stamped on roller

Dear I need this missing part, for a window non-tilt Thanks

Hi these small plastic serated pins are on my sling window two at the top that keep it guided when opening most have simply gone

Hello, I've ordered the following parts for my non-tilt windows and need help identifying the button or plug piece that plugs the holes towards the bottom of the window. S800-21 : 21" Series 800 Channel Balance 18-036 : 1/2" Top Sash Guide S800-17 : 17" Series 800 Channel Balance The first pictu ... (cont.)

I am looking for these spring loaded guide pins for a sunroom porch. The are the ones that use thin plastic & installed like screen Thanks, Tom

I have old viking windows and need to replace the balance on many of them. On the window frame I found the label: Viking industries Spec: DH-B1-HP (45) Series: 80/85 MST: 4066 On one of the balances I saw 2830 marked. On another 2280. Is there a difference between 2830 and 2280? It is a h ... (cont.)

A window pro recently replaced the glass in one of these windows. In the process, he lost the four little nylon dome-shaped buttons that were attached to the inside face of the moveable part of the single hung frame, cushioning between the moving frame and the fixed one. They were apparently frictio ... (cont.)

I

Small plastic buttons or plugs, that fit into 3/16 inch holes, on the sides, near the top and bottom of the frame of sliding glass patio doors. These slider buttons protrude out a very little bit aprox 1/8 inch, are where the door makes contact on side with the track(s). Need 6 each for one door. ... (cont.)

Hello, I have an apartment that was built in the 1960s. These window rollers have worn out and needs new felt. Do you have a replacement part for this or know where I can get them?

they look like rubber nails on storm windows there is alson a rubber or plastic part in channel next to rubber or plastic nail

My patio door has 2 nylon guide pins at the top of the door(inside)that are rather worn. It is a round pin approx 3/8 dia x 1/16 thick. It pushes into a hole that is 7/32 dia ( measured with a drill bit). I don't see anything like this listed for patio doors. Any suggestions? Thanks John ... (cont.)