Viewing all customer Discussions for:

89-018 Narrow Sliding Door Keeper, 1/2" Width

I have looked everywhere for replacement keepers for our porch doors/screens. The doors have labels that say they were made by Ashley Aluminum SA but it looks like they are no longer in business. Per my photo, they are 3/4" wide, 4" long and the part that accepts the door latch is approximately pr ... (cont.)

About 16 years old Sliding Glass Door Latch and keeper. Keeper hole center is about 3"

This is the piece that the hook on the sliding door lock hooks into. It mounts opposite the lock mechanism on the door framer with 2 screws. This one broke so I cant show it mounted very well. It is 2 3/4 inches long. Thanks

Hi I am looking for a single point keeper at is 4" in total length. The screw hole centers are 2 3/4" and the the width is 3/4". Any help would be greatly appreciated.

Hello, I am glad I found this site. Your replacement hardware seems to be the closest match to my needs compared to the big box hardware stores. I need a complete handle set (handle, mortise lock, keeper) because the house I now own has a sliding glass door that is missing everything. I believe ... (cont.)

hello, . I phoned last week to talk with your customer service department. They made a record of my call in your computer system. I was told to send this email with attached photos of my sliding door. I am looking for a replacement Keeper for a Remington Mark II 6068 sliding glass door. One of your ... (cont.)

Have sliding door lock keeper broken, this does not allow the door to be locked. The door must be of the late 1970s or early 1980s. I need 2 pieces. Thank you

We have PGT sliding glass doors that we'd like to be able to lock with a key on both the inside and outside. These doors are never used and don't want to take any chances with our little one getting outside where there is a pool. We have a normal swing door right next to the sliders, so no worries ... (cont.)

I'm not able to find this lock. If you have this style, I'd like one. Or if you can recommend one that will work for me as well. Door is - 1 1/4 inch thick.

This is the condition from time of purchase. Looking to ID proper mortisse and handle to repair without replacing door at this time. Thank you.

Not sure we can fix this so do you have a replacement?

Goes to sliding glass door.

No latch for door to lock onto

I ordered sliding door handle set 82-002 after researching it on your site. The handle fits perfectly but when I install the unit sent, the hook is upside down, meaning the hook wants to go up into the catch from below rather than down into the catch from above. All the hooks of different sizes se ... (cont.)

Metal latch needed for sliding glass doors.

I was looking for a Marvin Screen Stop and sill strike. Part # 05700030 or 05700029. The handle is a Ultimate Screen Handle or a Marvin sliding screen door. The handle is okay, I just need the locking latch.

The 82-002 lock set shows that it comes with a lock keeper. Is this the 1/2 inch wide keeper or the 3/4 inch wide one?

I need to replace a patio door inside pull. Stamped as DNS Industries 16 inside pull standard. Patio door locks and unlocks from inside only. Measurements match your 82-008. 7-3/8 X 15/16. Screw centers 6-5/8. But Your latch is facing down and my latch is facing up. Thanks Lydia

Hello Swisco Crew! Pete Rose here from Home Hero Handyman Service in Philly. Good friend of the infamous Mr. Paul Pallas. Hoping your team can help me figure out a replacement handle for the above referenced patio slider. Total length top to bottom is about 7.25" LMK if you can help me ... (cont.)

Need help please locating a part for my patio slider. This piece is attached to the jamb and the latch locks into it. I have no idea who made the door. Thank you