Viewing all customer Discussions for:

95-031 Square Cut Corner, White

Do you have 5/16" x 3/4" corners that will fit my screen frame? As I repair torn screens, I suspect that I'll have several that will break when I remove the screens because they're so brittle.

I am looking for corner keys for a screen frame with and without the stop.

1 3/4" length both ways, Corner square is 3/4", width 1/2", thickness of sqare part 5/16", thickess of slide in part 1/4"

These were installed when the house was built over 20 years ago. I'm trying to find replacements, preferably with the same type of 'stop'. My line is a little short but the 1.858 inches is the full length of the side.

Need assistance with finding theses corners please

Hello I'm looking to replace a few cracker corner end of my screens and having an issue locating the correct ones. I have attached a few photos with measurements. Thank you Harold

I need at least 250 screen corners if you have them

Square in the corner is 1"x1". Thickness, 11/32". Tabs are about 1 7/16" x 1/2".

My screen Frame for my pet window is a 1/4 inch frame for a storm door/pet door. I will not replace the door because the 2nd generation wildcat paws at it and I will or a pet door after I take this door off and make the modifications to the door.

Hi! Do you carry this window screen corners

I have 8 Better Bilt windows. Four of the screens are approximately 3' x 2'. Four of the screens are approximately 2' x 2'. I need new corners for each screen. Half of the corners need to have the little pegs that push up to lock the screen in place. Also, I need to replace the spline. I will ... (cont.)

I have to rebuild a few screens that come out from the inside. The top corners match the corners 95-264. They have a lock feature and a pin stop on the outside of the corner. I'm having trouble finding the bottom corners. Like the top corners they have the pin stop on the outside, but there is no lo ... (cont.)

I need help to identify these 2 corner parts of a window screen frames. they were made in the year 1999-2000 time frame. one corner has "807" on it.

I hope you got the photos of the Kolbe Kolbe corner connectors for screens. I tried the 95-031 but it didn't fit.

I'm looking for this specific corner

looking for this screen corner

HI, i purchased size 95-186 but they are a little too large. (Screenshots attached) is there something a little smaller i can try so i can fix my broken screen tabs when i rescreen? the worn looking ones in the pictures are the current ones and the newer ones are the 95-186 size. for comparison. ... (cont.)

I need several of these from screens made in 2000 or so. 3/4" 1/4" thick - 1/2" wide - number 509 embossed inside one -- smooth sides

I have a lot of windows to rescreen and I'd like to try your foam spline and invisible screen. My current spline size is 0.125 and is the vinyl ribbed type. I saw a post on your site that suggested using foam spline of 0.140 diameter for this application. Is that correct? Also would you have a part ... (cont.)

Looking for a screen cut corner that matches the Screen Corner Latch with Pull, 7/8" x 5/16"product code 95-218. Tried product code 95-031 but that did not work.