Viewing all customer Discussions for:

95-031 Square Cut Corner, White

Below you will find the pictures of the part that I am looking for. The measurements for the screen corners are 1 inch long and 9/16 wide.

Do you have a corner key like this? W=0.525, Thickness= 0.252, L= 1- 3/4, Square Corner= 3/4"....This fit into a 5/16" extruded screen frame and the wall thickness of it is 0.050.

The screen corner measures 5/16 X 3/4 as shown for your product 95-031. The 5/16" X 3/4" I purchased at the hardware store, the arms that slipped into the aluminum side are bigger then the slot in the aluminum. The dimension of the slide in part of the corner appear to be 1/4" X 1/2" X 1 1/8". Can y ... (cont.)

Hello, please refer to attached sketch. I was checking your website but cannot verify. Do you have a window screen corner that will replace this?

This is a corner for a Champion brand frame Can u get them?

Better Bilt Mfg code: BB-1 I found one in your catalog, but you show the width as 5/16" PN:95-031 I think your picture is marked wrong because it looks exactly like mine. Mine is 1/4 deep, but is 5/16" tall. I think your measurement is shown on the wrong place.

screen framing is 5/16 x 3/4

Hi, My current window screens are in good condition, but the corners are falling apart. they look like the 95-031. My question is, is there a similar item available that is a 2 piece. I do not want to remove the screen to insert new corners. I could not figure out how to insert 1-piece corner ... (cont.)

I'm looking for plastic corners for a window screen that have plastic sliding tabs built into the corner. similiar to your 95-111, but the tab slides up and holds the screen into the frame. made in left and right hand configurations have anything like this? regards Ed

I have a screen with broken corners. They require a straight cut corner. It's not clear that any of the Swisco parts will fit but I could possibly modify one of yours if needed. The square corner piece is ~15/16" x 15/16", thickness of the "insertion" ends is 3/8" the width of the insertion ends is ... (cont.)