Viewing all customer Discussions for:

95-073 Window Corner Tilt Key

Need the tops of the combination windows

Looking for parts for these old single pane windows. The bottom locks are @ 4" long x 1/2" wide. The white corner clips are @ 1 1/2" long x 1/4".

Looking for this part. No information available

Could not find them. Corner with tilt pivot and guide. I ordered the wrong part 95-193.

Single pane vertical window glide/guide post

I am looking for zinc die cast corner keys, top tilts, and left and right spring latches for extruded aluminum triple track storm window repair. Attached are photos showing corners of screen. Please let me know if you can supply the correct parts.

Team, I would greatly appreciate some assistance with replacement parts. I'm trying to repair my sister's aging windows while she gets back on her feet. I'm looking for plastic corner keys, wheels, and glazing strips replacements. If you can point me in the right direction would be appreciated. Ple ... (cont.)

I would like a quote for replacement top and bottom tabs. See pictures. Fixed on the top and spring loaded on the bottom.

I am looking for parts and saw your items # 95-073, 95-190; 95-191 for the top tilt keys and the bottom latch keys (left and right) items # 99-033p. The latch is 3 5/16 long. I removed existing parts from the screen window and measure them out for youCan you confirm what items would work for me. ... (cont.)

I'm looking for replacement bottom latches and top corners (with the pivot points) for these storm windows. Note, there is a small raised point on the outside of the latches that key into the frame

latching 36" wide storm window on a colonial house. Currently 35 yr old plastic. Windows mfg by possibly "Solaire " not sure. About 23 sets are needed.

one of these corners is 1-1/2 inches north to south and 1 5/8 inches east to west. With a width of 1/4 inch. The other corner is 1-3/8 by 1-3/8 inch With a width of 3/16 inch. A Swisco rep suggested that I purchase 95?016 for replacements However they are too thin and don't catch inside the slides. ... (cont.)

I need some vinyl/plastic corner tilt/swivel keys. The thickness is 3/16, I need some that are (inside the corner dimensions) 7/8" long/wide on the top (not including tip) and 1 1/4 wide on the bottom (not including tip), with a 1/8 diameter pivot. The dimensions including the tips are: 1 1/8" w ... (cont.)

We can't find this exact piece for storm door windows

The black, corner plastic piece that you see, the round part sticking up tends to break and I need about a dozen (12) of them. Hope you can help! Thanks Rick

The pin broke off one side. So I am seeking a replacement part. Plastic insert into storm window frame, the extruding pins on either side fit into the grooves on the door frame allowing it to slide up and down. The frame is aluminum, pretty old.

Hard plastic with right angle pin. They slide in track to allow window to self store!

I need this little clip that holds the window frame and glass in place

I'm looking for the pictured guide. There are on top of the moveable windows and screens. I have several broken off.

I am looking for some information on where to purchase these same sash tilt corners. They are much smaller than most of the corners we use, and I can not seem to find an outlet for them.