Viewing all customer Discussions for:

18-057 Top Sash Guide, Binnings

The plastic corner on the window pane that moves up and down held on with 2 screws. Appears to help guide the pane up and down against the balance.

Both of my channel sash guides are broken. The only numbers I have are on the channel springs which is 2730v

DO YOU CARRY THIS ITEM FOR PURCHASE

I need a replacement sash cam with the following dimensions -- 1 7/16" wide at top -- 1 1/16" long at top -- 1 9/16" long from top to bottom -- two screw holes set 7/8" apart (from middle of screw hole) -- screw holes are 1" from top to middle of screw hole -- bottom part where screw holes are is ... (cont.)

35 year old, non tilting, single hung windows. No brand or part numbers on top sash guide or windows. If it helps? Channel balance is a 28" 27-3 Looking for a replacement top sash guide (hopefully in white)

Greetings. Is there any hope you might have any sash guide anywhere near this size and shape? Thanks, Doug

Having a tough time locating this size sash guide. You always came through in the past. Hope the pics help you.

My window balance fell from the window pane and now needs to be replaced. The the spring is detached from the pulley as shown in the attached 3 pictures. I think that the maker of my window is "nami" as shown in the 4th picture (the window's label). Can you identify the balance so i can order its r ... (cont.)

looking for 20 caps to go on top of my window balances Top measures 1-7/16 x 1-1/8. overall height 1-11/16 width 5/8" under cap. 2 screw holes

Hello,There is a plastic piece at the top of the side of the sash, that holds down the balance when the window is lowered. That piece is broken: so the balanceon that side just pops thru when the window is lowered.I'd like to get a replacement piece. Thank you!

I'm looking for a Top Sash Guide that is 1-1/16" wide below the cap (i.e., measured below the cap); 1-7/16 wide measured across the cap; 1-1/16" deep (measured at the cap), and 1-5/8" long. Do you have one that fits those measurements?

I need to replace the channel balances on a sliding (non-tilt) window but I have some questions: First, It is a very old building and I'm not sure the ones that were previously installed were correct in the first place (exactly correct model, length, etc). Is there a way to determine the exact co ... (cont.)