Viewing all customer Discussions for:

S370-29 29" Series 370 Channel Balance

Need replace the window balances on six different windows that are all 3' x 5' non-tilt aluminum window windows

Hi, I need this part. I believe it has one on each side of the window. The length of the channel is twenty nine inches.

Hi, the balance are 29" long not counting plastic adapters, approximately 1/2"X5/8" , stamped 2830 J. Sorry, I didn't have a picture of there installed. The bottom is the beige and the top is the black retainer/track guide.

I need block and tackle typs channels in the following sizes with the ends and hooks as pictured. Channels measure 9/16 wide x 5/8 deep. I need: 2-17" stamped 1620 8-23" stamped 2230 2-29" stamped 2810

Hello my name is Jose I am trying to find the right balances for my windows.I and there are 29 inches long and the number on the part is 2820Z . thank you I will wait to hear from you

I want to verify my selection before ordering. I have shown one of the parts in the attached images. This is a 17" long balance. I also have 29" balances to replace. The 17" balance is stamped with 1610 and the 29" balance is stamped with 2810. To replace the 17" I am planning to order 17" Series ... (cont.)

I am looking to identify the correct balance to get for my windows. So far they are all 2810 balances from aluminum windows but want to make sure I get ones with the right shoes and tops.

It measures 29 inches . Also need the clips! Thank you, Seife

The balances are 29". They are stamped 28A. The sash weighed 10#. The upper ends that go to clips were broken off and the balances were slid all the way to the bottom of the track. No pieces remained.

pictures are for 29" channel balance and previous order

I have two sizes of windows, a smaller and a larger that I need 2 balancers for the smaller window and 1 for the larger.

Hi there, have 2 windows that need lifts and any other possible hardware for repair 29 1/4" long ANSI/aama 101.85

have a window with 2 bent balance rods with missing springs. No wheel is on the bottom. I believe it may be an S370 from your pictures, but I have some pictures for you below. Please tell me the price and when you could ship them or return me to a local Swisco shop near Parker, Brighton or Denver ... (cont.)

Single side non tilt balance, marked 2830. Unfortunately the foot part is broken so it's hard to match to the photos. It doesn't appear to have anything on the back side, but it's close to the s370 model. 1/2 wide, 29 inches long.

I can't find a window balance that has a flat top and a bottom without wings. This is an older window so I'm hoping I can find the right window balance.

I need at least a dozen of these channel balances for a rental home in Sicklerville. The current ones are frozen and non functional. The metal part is 29" long. My name is Ron. I'm a handyman working for the homeowner.

Hello! Would you be able to identify the channel balance based off the photos? The top is broken off the only 2 I have access too and am nervous about just guessing. My guess is rather S380, S385, or possibly even S700? Based on the possibility of "wings"? Thank you so muvh!

Hello - We are looking for assistance in identifying this 29-inch channel balance (2810 stamp) so that we may order several units. Also pictured is a "window end cap" and we would order several of those as well. Please let me know if there is additional information we can provide. Thanks in advance ... (cont.)

The plastic tips were broken. The clip was unable to find, but the id number is 283088067F. Could you please help to identify the replacement?

Please advise me what model channel balance I need to order