Viewing all customer Discussions for:

S377-24 24" Series 377 Channel Balance

Number 23-3. J. Stamped onto part. Metal portion without plastic ends 24" long. Need 4 total.

Window spring say j 23-2. Metal without plastic peices are 23-7/8". Need help identifying.

Hi copulkd you help me find out what part I need, both sides of the windos are broken. The size of the window is W52" x H49.5". the lenght of the metal bit is 24" and the width is 1/2".

Need a 24 in window sash balance replacement for my window. Has a stamp of 23-1 in it.

Length 24" (metal) model 2320:

Need to find a replacement for my non-tilt window balance rods. They measure 24" long and 1/2" width Photos attached

Hello! As shown in picture, the part number on the old window balance is A2320. The balance is 24 inches long. Please let me know which replacement number I need to order.

I need right and left sides

Hi, I have channel balances from 1980. The top plastic fitting on mine do not exactly match the photos of the options shown on your website, although the "option" available is 2320 which is embossed on the channels I have. I just want to make sure I am ordering the correct ones.Thanks,Rodney ... (cont.)

Just about 6/8" in width

The metal shaft is 24" long. 1/2 wide Printed number on shaft 2320 I've included pictures with measurements of the top and bottom.

Hi I'm in need of 8 channel balances. Single hung windows The silver metal part appears to be 24" long with only markings of 2320F. These are from original build here in Port Saint Lucie Florida which was back in 1984. I recently ordered 2 small parts for the sash.

I need 2 balancers for 1 window please. Single hung no tilt

Good afternoon, can you please help me identify these channel balances and point me in the right direction? they are 18.5 inches long (not including plastic end pieces) and the only marking I can find reads "1840-" They appear to be just over 1/2" wide. Please let me know if you require any addition ... (cont.)

I need a window channel ballance with all parts including the top sash stops, the balance and the balance remover clips. See the photos I sent you. Details: The stamp/number on the balance: 2320P. See the photo. I need the balance remover clips. What I have now is plastic. I also need the sash top ... (cont.)

Trying to get exact balance, photos attached

I have an old 24" window balance with the stamp 23-3 on it. I do not see this part in your catalogue. is there an updated equivalent part? Thanks

I need the complete window balance

I am looking to see which is the correct balance to order for replacement, and which part numbers would be associated with the plastic guides on either end. I will also need the replacement part which goes on the top/bottom of the slide window as well that holds the balance in place. ... (cont.)

Need channel balance for Binnings Pan American model/series PA-14SH non tilt 25 inches long Stamped 23B