Viewing all customer Discussions for:

S380-27 27" Series 380 Channel Balance

I need 2 29' channel balance and 4 27' channel balance and 8 sashes. I included pictures of exactly what I need.

Hi, I've got a 27" channel balance on a number of windows and need replacement balances. It's got winged top and bottom plastic fittings and the marking on the side is 26-3 FK5 CMC 43 It matches all the specifications / look / measurements of the "27" SERIES 385 CHANNEL BALANCE" from your channel ... (cont.)

Need window balances 1. Stamped 26 4bsi / ng 2. Stamped 26 2bsi / ne Can you help with the correct balances to purchase? We have 2 windows that are #1 and 4 windows that are #2. Thank you for your help.

Milgard single hung window. Stamped 2640 LM

It said UP 26D

Rod is 27 inches long measure without ends and 1/2 wide

Hello I could sure use your help in identifying these balances so I can buy quite a few of them from you as they seem to be breaking in droves for some reason. Thank you for your time and help.

I think I need the same part for 12 year old Mercer windows and the part number on the balance sash is 26 4 BA CMC 11. Definitely. 27 inch Thanks, Phill

Dear SWISCO experts,Please confirm and advise what size Channel Balance should I purchase it. Attached please find the 5 photo which are my old channel balance.Your sooner reply will be appreciated.David

The string and one small part on the end was broken one day, and i think need to replace the whole part. could you find this? what's the cost of the part and the shipment to San Jose, CA. thx!

Balance is 1/2" wide. Metal part of balance is 27" long. If including plastic boots, the entire balance is 28" long. The bottom boot has #15P102 and a 3 below that number. The other balance's bottom boot has the same part number but a 4 below it instead. I can't seem to find any part numbers for the ... (cont.)

Please confirm and advice what size balance channel should I purchase it. Attached 5 photo for your reference. Many thanks. David

Definitely 27 inch metal part. The ends are definitely one inch, not 1 and 3/32". The stamped marking is confusing me. All I can find is 26B. Can you help me with this information and theses pictures?

I'm trying to make sure I get the correct non tilt winged Caldwell window balance

Do you have this part in stock? And how much? Thank you!

I need to find correct part# for 2 Sizes of window balances both 1/2" width but one is 27" long and the other is 15" long. Measured just the metal piece not the two plastic fittings on the ends.

Can you please help me to identify the right replacement part, please? The channel length is 27" and depth is 1/2". Thank you.

I have a roughly 28.5 x 57 window that I need to repair. Attached are photos of the piece that came out as I was attempting to close the window. The metal piece measures 27".

The marking on the balance is 26 5 FR CALDWELL The length of the metal part (not including the shoes) is 27". The bottom shoe is 1" deep measured from the wing to the other end (measured at 90 degrees to the metal channel). I think I have to get 380-27 27" Series. Could you please confirm that th ... (cont.)

Can you tell me which one I need to order from you guys. Thanks Randy