Viewing all customer Discussions for:

S380-27 27" Series 380 Channel Balance

I need both right and left complete set. 17 inches long 3/8 inch number marking is 26 4 B.S.I 2006 build year from Karsten Manufacturing

I need six window balancers please....

I have two windows which need to have the sash balances replaced. 1st window has numbers listed as: 26 4 CW CMC 10 and the pictures are for that one. 2nd window has numbers listed as 20 4 LV CMC 2. I had to put that window back together so didn't get pictures for it but the sash balance looks the e ... (cont.)

This is my window balance spring which is 27" long and 1/2 channel. Please let me know the replacement for this? Thanks, Mark

It's 27 inches long and 1/2 inch width . Please see photos. Has markings ie 26 4 EV CMC 7 and the other has 26 4 DV CMC 7. Please help me identify the correct parts. Thank you.

Please help me find/order two replacement springs for my window. Thank you in advance for your assistance =)

Metal only length 27" 1-2" wide 5/8" deep The black ink on top stamp 26 3 GW CMC 11

Hello: We have single hung windows that need replacements balances; could you recommend an appropriate balance? Please find photos of the markings, as well as views of each end. Thanks in advance.

Need replacement parts for windows. Stamp with markings are in photo.

My window balance broke and I need a replacement

Hi,Balancer was taken from a Milgard window presumed to be 17 years old.Pictures attached show details of the "good", or working balancer.Top and bottom ends and underside detail is shown for the that balancer.A number printed on the top side reads: 26 5 EW CMC 11The bad balancer's pulley "rope" ... (cont.)

Possible part number (stamp) 26-4 JU CMC 7

Need to balancers Please advise THanks Bill

when I raise the windows sometimes the channel balance does not reain fixed to the sash. ideas?

Hello Swisco, I would like to replace two window balancers for a Milgard, single-hung non-tilt window. The width measurement is 1/2" if I measure the top, 3/8" if I measure the width across the bottom (where spring is visible). The length measurement is 27" for the metal bar only or 28" when I in ... (cont.)

Hi Swisco, I have two Milgard windows which are broken and are the same size. I need to replace this entire balance assembly (2 per window, 4 in total). Stamped on the rail is "26 4 GU CMC 4". Overall, I need to buy 4 assemblies as well as the "Take out clips" which were all broken. Can you please ... (cont.)

The balance measured 27" and 1/2". Pictures are uploaded as requested. Would like to have this balance identified so I can order the correct replacement part.

Hi, could you please help me identify the model I need to replace my window channel balancer?

Markings on the back show 26 5 BW CMC 7

Good morning, I'm looking to order several replacement balances. The total length is 28" plastic tip to tip. The metal bar is a hair shorter than 27".