Viewing all customer Discussions for:

S380-27 27" Series 380 Channel Balance

Hello: We have single hung windows that need replacements balances; could you recommend an appropriate balance? Please find photos of the markings, as well as views of each end. Thanks in advance.

Need replacement parts for windows. Stamp with markings are in photo.

My window balance broke and I need a replacement

Hi,Balancer was taken from a Milgard window presumed to be 17 years old.Pictures attached show details of the "good", or working balancer.Top and bottom ends and underside detail is shown for the that balancer.A number printed on the top side reads: 26 5 EW CMC 11The bad balancer's pulley "rope" ... (cont.)

Possible part number (stamp) 26-4 JU CMC 7

Need to balancers Please advise THanks Bill

when I raise the windows sometimes the channel balance does not reain fixed to the sash. ideas?

Hello Swisco, I would like to replace two window balancers for a Milgard, single-hung non-tilt window. The width measurement is 1/2" if I measure the top, 3/8" if I measure the width across the bottom (where spring is visible). The length measurement is 27" for the metal bar only or 28" when I in ... (cont.)

Hi Swisco, I have two Milgard windows which are broken and are the same size. I need to replace this entire balance assembly (2 per window, 4 in total). Stamped on the rail is "26 4 GU CMC 4". Overall, I need to buy 4 assemblies as well as the "Take out clips" which were all broken. Can you please ... (cont.)

The balance measured 27" and 1/2". Pictures are uploaded as requested. Would like to have this balance identified so I can order the correct replacement part.

Hi, could you please help me identify the model I need to replace my window channel balancer?

Markings on the back show 26 5 BW CMC 7

Good morning, I'm looking to order several replacement balances. The total length is 28" plastic tip to tip. The metal bar is a hair shorter than 27".

Need right and left 27 inch

My balance is 27 inches long, non-tilt, 1/2" wide.

I am looking for a replacement for this Milgard window balance from 2004

27" 26-6 BA CMC 11

I am seeking a repacement 27" Milgard Channel Balance. Below is a photo of the balance.

Hello I have the following balance installed in a single hung non tilting window. It will no longer stay up. I am unsure which to order for replacement. Thank you!

26 5 AP CALDWELL Printed on the face. Channel is 26" long by 1/2" Lower end measues 1 1/16". Part in window measures 1 7/16" by 5/8" by 21/32". Window weight is 24 pounds.I need 2 balances and, probably should replace the window guide piece.Thanks. Richard