Viewing all customer Discussions for:

21-154 Pivot Rod Clamp

Customer Service, one (1) pin on the lower section failed on this set of doors. It is time to replace a door pins, springs, elastomers and tray/guide parts.could you kindly provide the Part Numbers to replace all of the hardware? The steel doors remain in good condition. Thank you.dwight ... (cont.)

would like the correct pins for replacement on the hinge and guids

Looking for replacement bushings

I need the bottom track for a 2ft wide door and the bottom pins.

Need pivot clamps to replace broken ones. Also need pivot pin springs like the one shown in the photo. Can you please provide part numbers?

Hello,I have a metal bi-fold closet door in a building built in 1974, and I’m looking for replacement guide pins for both the top and bottom. For the top, I’d like to use a guide pin with a spring, and I believe the same would work for the bottom as well.Could you please advise which guide pins I sh ... (cont.)

These are from a house built in 1970. We need hardware for 3 sets of bifold doors

i have leigh metal bi fold doors from around 1970, the pivot rods are 5/16 dia, the guide pins are 1/4 dia, i think i need, 2 #21-001, 2 #21-154, and 6 #21-007, if this is correct can you tell me the cost with post & packing & tax. thank you

Please help identify.

Hi there. We have these beautiful, original metal bi-fold doors that were an issue since we bought our house 5 years ago and I have been trying so hard to find updated hardware so that they not only look sharp but function. From watching your videos online I'm almost positive that I need your 21-007 ... (cont.)

Customer needs metal bifold doors rebuilt to close properly

Hi there. Do you stock such an item or have something remotely close. Please see attachments

Need 12 pin caps for all the bifold doors in the house

My name is Roy, I have 12 old metal bifold doors that needs new guide pins, springs on the top and bottom. Here is the door that I need part for please lmk thank you These doors are about 50 years old and all needing replacement. Thank You Roy

here is my problem. i have 40 year old metal bi-fold doors in all the closets. they are bolted together so they swing open like a regular door, so i don't use the pins on the mating edge of the doors, only the outside edge. on one door only, i can use the slot on the bottom pin and raise the door ... (cont.)

Hi I'm working in an old house with bifold metal doors in a closet. Owner doesn't want to replace doors just repair. The label on the door says Evans products company but I can't find any info on the internet about the doors or company. would you be able to help me match the part I need. only one se ... (cont.)

Please contact me regarding replacement parts

Hi, I have a Model "D" bifold door with glass. One of the bottom pivot broke and I need a new one. See attached photo. Would you be able to point me to the right part? Thanks. Thanks for your help. I attached some pictures of the bottom pivot that broke and didn't slide well on the bottom t ... (cont.)

Can you sell me this pin?

Hello, I have some old metal bifold doors. I'm looking for everything in the picture and the doors look pretty much like this. But I mostly need the stuff for the top. Everything basically including the plastic piece that goes into the track that sits on the pin.