Discussions for 75-503 : SWISCO.com

How to install your Screen Plunger Pins

I bought some screen plunger pins from you this week(see attached photo). I believe I received the incorrect black plastic snap covers. I would think that the plastic tabs would snap into place at the narrow end of the pin to keep the plunger pin from sliding out of the screen. These black plastic c ... (cont.)

Screen Pin

I am looking for the pins that screw in at the top of the screens and can't find them. I attached a picture of the pin I took off on one of the screens as an example of what I need.

Screen spring pins

I have screens from 2003 and the manufacturer went bankrupt (Bonneville in 2009). I need replacement pins, but nothing matches the size pin I need. The inside screen frame hole is 3/16 inch wide, and the outside frame hole is 1/4 inch, or maybe 7/32. The problem is the inside (3/16) hole. The probl ... (cont.)

What size holes need to be drilled on the outside and inside

What size holes need to be drilled on the outside and inside of the frame?

How to install 70-219 plunger pin

How do I install this item in a newly made aluminum screen frame?

plunger pins and pull tabs

I need to replace my plunger pins. what is the difference between the 70-008 and the 70-009? Are there white plunger pins? do you sell white lift tabs and does one size fit all? What is the difference between the step down drill bit 75-032 and the 75-503? Price is better on the 75-503. ... (cont.)

The drilling part for a plunger

Do you free hand the drilling or us a jig when drilling the hole for the plunger

Step down drill bit question

Can you explain the price differential between 75-032 and 75-503? Which is most common?

replacement pins for screens

I'm trying to figure out which pins will replace the ones have been holding the screens in place for the last 15-20 years. The frames are about 3/4 inches wide and measuring the holes, the 75-503 drill is about right.

STEP DOWN DRILL BIT 6" LONG 5/32" X17/64" 5/32" IS 1/2 " LONG

IM LOOKING FOR AT LEAST 3 BITS CAN U FIND THESE & WHERE I CAN ORDER THEM ITS BEEN YEARS SINCE I BOUGHT THESE THE PERSON I BOUGHT FROM IS OUT OF BUSINESS HOPE U CAN HELP

Step Down Bit

I bought the 75-503 step down bit to use with the 70-008 plunger pins. When I drilled the hole and went to install the plunger pin, the pin when all the way through the hole. Is this correct? From the video, the metal head of the pin and the spring should not have gone through the hole. ... (cont.)

What sized plunger pin works with the 75-503 drill bit?

If I buy the step down drill bit (7/32 down to 1/8 inch), what size plunger pin would work with this? Thanks!!!

Why is the 75-032 more expensive than the 75-503?

Hi, I was wondering (other than size) what's the difference between the two step down bits & the plungers associated with each? The reason I ask is that the 75-032 is far more expensive than the 75-503. I understand there are two different sizes, but why such the price disparity? Does the 70-0 ... (cont.)

Viewing all customer Discussions for: 75-503 Step Down Drill Bit

Viewing all customer Discussions for:
75-503 Step Down Drill Bit