Viewing all customer Discussions for:

82-048 Andersen Latch Mechanism, PS 3 Panel

Could you please confirm that the lock bolt assembly PS 3 panel listed in your catalog #82-056 is a match for the attached pic? I believe my sliding door is Andersen from circa 1989Many thanks Patrick

Our home was built in 1992 and the exterior hardware of our gliding three- panel door is broken and I?m not sure what part or parts I would need to fix it. Here is a pic of the broken hardware.

Wondering if these are installed correctly or need replaced? Our door will not lock at this point. It feels locked but if you pull really hard it will open.

I have Andersen, 82-048, 82-049 and 82-056. Do I need both 82-058 and 82-057 to make my door lock.

Please see enclosed pics of a broken exterior patio door handle. It doesn't seem to be an Anderson because of the extra vertical flat bar at the base. Can you recommend a replacement with screws? There are two markings on this handle. one marking has an "A" with a circle around it. The other marking ... (cont.)

Please take a look at these three pictures of my sliding door latch to help identify the parts that I need. Thanks, Mike

Hi there, Seems its time to replace the entire lock system on my old Anderson 3 pane sliding doors. Would you have these parts (pics attached) or something I can retrofit? Thank you very much. Best, Harvey

Looking for replacement parts for locking mechanismi and brackets surround ing it on Anderson 3 door slider from around 1990 instalation . I see the lock but not the 2 brackets. Need 2 sets.

Hi - I can't find any latch that matches what we have. Everything available seems to have a reach out latch that extends into the jam. Our door slides inside one of the stationary panels and latches to the interior of that fixed panel. Do to salt air, everything is corroded quite a bit and should be ... (cont.)

Does 82-057 consist of two pieces or one? (Interlock Bracket, Operating/Meeting Stile 82-057) I have the old style three panel sliding doors, and am of the impression that I would need to order Andersen PS 3 Panel Interlock Bracket 82-058 as well. Is that correct? I wish to replace the Interlock, bo ... (cont.)

I have a panel sliding door by Anderson, vintage circa, 1982. My door lock is not working. It turns but do not latch/lock not sure whihc parts I need. I am trying to fix it and I need weatherstripping, and rollers for the bottom to slide easier. Not sure exactly what parts I need, see picture ... (cont.)

I got this part from you guys and I forgot to order the hardware that locks the door, you know, the part that goes inside the door

We cannot get replacement parts for a Pella glass door slider. We need the vinyl strip that are on the inside and outside of the door where the handles are. We also need the inside handle, which apparently has been broken off over the years. The vinyl strips measure 79" top to bottom. I h ... (cont.)

I need to replace this bent and rusting lock. The exterior key lock is inset with a cap around it that us flush to the door. The interior is a thumb turn that has Andersen written on it. The door is a 3 panel dr with the two sides stationary. The middle door slides into one panel and licks to it. Do ... (cont.)

Need to identify part number for replacement lock on Andersen 3 door patio sliding door set -- lock is between middle sliding section and stationary right door. Information etched below Andersen brand is: IGCC 306 CII-82S Here are 2 photos of the lock: photo 1 is the thumb know on the interi ... (cont.)