Viewing all customer Discussions for:

82-238 Double Hook Mortise Lock

Hello, I can not find any identifying numbers, not even sure about the manufacturer, possibly Farley. One of the cast handle mounting threads has broken. I just need the the handle nothing else. Is this something you may have. I think I see something very similar with 4-15/16 hole spacing. Just ... (cont.)

No markings or numbers written in hardware. We just need a new lock, not a whole set; if possible.

Does the 82238 mortise lock work with the 82081?

Sliding door will not lock, i was able to narrow that the lock is broken. I do not have an part number but I want to make sure that DOUBLE HOOK MORTISE LOCK is the correct part, in addition I added the photo of the hinge where the door meets as I would like to replace that part as well, hope to hear ... (cont.)

Hi, I would like to find a locking (tumbler and key) door handle for this Jeld-Wen sliding door. It was new in 2020. The bolts appear to be 5" apart. Can you supply one? Thank You! -Pat

Hello, I would like to replace the key lock. Are you able to me which keylock fit this mortise sliding door? Thank you.

Do you have any measurements for the 82-238 mortise lock. I have an old certainteed sliding patio door that is missing the entire lock handle and strike.

Could you please tell me of a part number for this I have 82-081 this is two pieces

Nee a replacement patio door lock. Attached is description in photos.

Hi I'm looking for the part that is the Lock mechanism that's mounted on frame of sliding patio door. Actual part is super small 1/4 inch wide about 1/2 inches tall. I hope you can help me. Thanks! Frank

I no longer have the lock and handle that were in the spot, but I measured 8 inches between the holes on the left photo

The inside handles bottom screw broke off and need to replace just the snide handle . The door isNFRC 100/200Code: HlL-2, rating:nfrc,series: SVPD, MST:7282Other part of sticker reads-NFRC H.l-2-017, 98MPlease advise as to what I need to replace the handle, looks like door was put in 2097, recentl ... (cont.)

Need lock set. Not door handles.

On 4/14/18 I received a replacement of my door handle. I only needed the latch but It worked. It has been broken again. I will buy the whole assembly if if necessary but I only need the latch lever

Hello, My sliding door double mortise lock is broken. The bottom mortise is stuck in the locked position. While the top works fine. I've removed the handle but cannot see any visible screws to remove the lock itself. The only piece with any marking is "made in New Zealand" the screws on the handle a ... (cont.)

Do you have the handle part that's missing with side screws?

I have an MI windows sliding glass door. The lock is a double mortise lock and won't release anymore. The plate is 9 inches and 7 3/4 from the center of the top screw to the center of the bottom screw. The total width of the lock appears to be 1 11/16 and 1 5/16 from the back of the screw on the loc ... (cont.)

I need help figuring out where I can purchase the handle for the sliding glass door it is a dual point but I cannot find the make on it appears to be a vinyl door

HI, I JUST ORDERED PART NUMBER 89-036. Want to maker sure this will work for my lock pictured above. I didn't see any measurements indicating where the locking points should meet. thanks order number 1573739

Door won't lock. Appears nub in center hole broke off, found lying on floor beneath lock. Need to replace/repair