Viewing all customer Discussions for:

82-238 Double Hook Mortise Lock

Hi I'm looking for the part that is the Lock mechanism that's mounted on frame of sliding patio door. Actual part is super small 1/4 inch wide about 1/2 inches tall. I hope you can help me. Thanks! Frank

I no longer have the lock and handle that were in the spot, but I measured 8 inches between the holes on the left photo

The inside handles bottom screw broke off and need to replace just the snide handle . The door isNFRC 100/200Code: HlL-2, rating:nfrc,series: SVPD, MST:7282Other part of sticker reads-NFRC H.l-2-017, 98MPlease advise as to what I need to replace the handle, looks like door was put in 2097, recentl ... (cont.)

Need lock set. Not door handles.

On 4/14/18 I received a replacement of my door handle. I only needed the latch but It worked. It has been broken again. I will buy the whole assembly if if necessary but I only need the latch lever

Hello, My sliding door double mortise lock is broken. The bottom mortise is stuck in the locked position. While the top works fine. I've removed the handle but cannot see any visible screws to remove the lock itself. The only piece with any marking is "made in New Zealand" the screws on the handle a ... (cont.)

Do you have the handle part that's missing with side screws?

I have an MI windows sliding glass door. The lock is a double mortise lock and won't release anymore. The plate is 9 inches and 7 3/4 from the center of the top screw to the center of the bottom screw. The total width of the lock appears to be 1 11/16 and 1 5/16 from the back of the screw on the loc ... (cont.)

I need help figuring out where I can purchase the handle for the sliding glass door it is a dual point but I cannot find the make on it appears to be a vinyl door

HI, I JUST ORDERED PART NUMBER 89-036. Want to maker sure this will work for my lock pictured above. I didn't see any measurements indicating where the locking points should meet. thanks order number 1573739

Door won't lock. Appears nub in center hole broke off, found lying on floor beneath lock. Need to replace/repair

This part goes between the door handles of the sliding door.

We looking for this Morttis lock we only have the front face keeper size is 8"3/4 from end to end and 3 from hook to hook on the morttis lock. We need the Morttis lock and the front face keeper. Thanks.

I am looking for this kind of lock set. Also my doors are heavy to slide open and close. Any advice. Thank you

I have a Certainteed sliding door that I am missing the interior handle. The mortise has a stamp that looks like 2 capital I's. It says made in New Zealand. That is about it.

Our sliding door lock does not work. Can you provide information on the type of lock that should be replaced. Thanks Peter

I'm hoping to source a replacement patio door lock. I've attached photos showing a working patio door lock for reference (the two hooks are out) and the broken part - where only one hook works. There was a broken piece inside the lock such that one hook doesn't move anymore. This part is almost ide ... (cont.)

Will this keyed locking handle work on a Milgard patio door? It has the double jaw mortis latch

I do not know manufacture of the door or door lock.

HelloWe need the wall plate that matches the door handle, do you by any chance know what this may be, do I need to take any measurements.If we cannot find a math do I need to buy a new handle and matching plate?Thank you! Alison