Viewing all customer Discussions for:

23-148 Track Stop

These are the parts to the door. The door does not have any markings. Let me know if you need anything else Thanks, Crystal

Need help ordering correct parts for closet bifold door track.Old track is on right in photo, new track is on left. Bracket does not fit into either track.Do you have a bracket assembly that would fit onto the old track on right?The old assembly is both metal/plastic and is broken.New brackets purch ... (cont.)

Hi, Do you sell the bifold door track that is compatible with the 23-266 - Pivot Guide? Thanks, Mike

Hello... I'm looking to replace a 60-inch 4 door bifold track. I saw your product #23-455 that looks like it could be a good replacement for my old 60 in Johnson tract. I was wondering which top pivot bracket assembly would fit it and could I use the existing top pivot currently attached to the to ... (cont.)

I am looking for replacement hardware for the doors. It sits on top of door. I am told it is the door stop. It prevents the door from sliding when opening and closing. Thank you

THIS PART ATTACHES TO THE TOP OF THE FIXED STATIONARY DOOR OF A BIFOLD DOOR , THERE IS A NAME ON THE PART JOHNSON

We lost one of our pocket door stoppers on the top part of the door. This is the one we have on the other side. Need to replace it. Thank You.

Hi. I'm looking for a replacement part for my bifold doors. It's the top pivot bracket that won't tighten anymore. Is this something you might carry a replacement for?

I have bifold door that came out of a closet in our bathroom. It was removed a while ago and was not the one that removed it. I installed the door in another room but don't know how it is suppose to be assembled. The part I am trying to figure out is the top pocket socket part 23-307. When I t ... (cont.)

Need stopper for the door

I lost a support part for my folding closet door.Now when I open and close the door, it's not supported and scratch against the bottom railing. I must lift the door by the door knob to open and close it.Nothing supports the door spring.valerie C

Hi! Bought a new track from you guys and of course my old door hardware doesn't fit! The doors don't have a hole for the types of pivots I see on your site. Am I missing something? Please advise! (Husband won't help me.) Thank you!

Hello, we are trying to identify these parts for the top of a bifold door.

looking for a couple of parts, information that I gathered from the top pivot Guide,the spring loaded one has a pat. No. 3397790 and Pat.Can. 1970. The parts that I'm looking for are the ones on the picture d and e. or other parts that will do the same job.The one on the picture d runs free on the s ... (cont.)

Help! The top bracket is broken and I need a replacement. The track is 3/4" wide on the outside and 7/8" from top to bottom. The pivots do not retract. I need the top bracket and the rubber stop at the far end. Can you identify these parts? Photos attached. John

The top pivot roller on my bi fold closet door came unhinged. The spring holding it in popped out and now it won't stay in the top hole of the door. I need to replace the pivot roller. It is a 3/8" top with a 1/4" bottom. Attached are some photos. Please let me know if you need anything else. ... (cont.)

This pocket door has been abused by a rental guest and one of the stop lock clamps has been yanked off and cannot be found. Can I get a replacement? The inside measurement of the track is 1.5 inches. Thank you, Robb.

I ordered the 23-148 butit seems too narrow or attached track. There were no installation instructions so I am not sure if it is the wrong hardware or I am just not installing it correctly given that I am not sure how it sould be installed.