Viewing all customer Discussions for:

82-239 Multi-Point Mortise Lock and Keeper, 9-7/8"

Hi: I have been searching all over for the replacement lock for my patio door. Please advise if you carry.

stamped Pat Pending

No markings on lock except "Pat Pending". Door is 5 years old, probably Reliabilt, which I'm told by Jeld-Wen could be theirs or Atrium or someone else's, since Reliabilt is a Lowes generic product name. Length between mounting hole centers is 9-7/8, thickness is 9/16. I'm concerned about the act ... (cont.)

I need the inside of the handle lock My doors are 6 rb dp50 vyl patio dr with screen and blinds in between glass I need a lock replaced I need a new part

Swissco 6.264.252

Need to replace.

Looking for a PSLMLDH524 double hook mortise lock. It is coming out of a Reliabilt by Atrium 332 sliding glass door. I think that this 82-265 might work. But would like to confirm.

Latch quit moving stuck in up postion

Looking for a replacement lock for a rear slider. It appears to be the SS Multi-Point Mortise Latch and Keeper, Product code 82-259.Or I guess the non-stainless steel version would be the MULTI-POINT MORTISE LOCK AND KEEPER, 9-7/8"Product Code: 82-239

Hello. We are looking for a replacement for a multipoint mortise lock, plate and handle for a Simonton sliding glass patio door. The patent numbers for the lock are 5820.170 and 6.264.252. The length of the internal lock is 10 inches from end to end. Would we also need a new lock plate attached to ... (cont.)

Please confirm 82-239? Do replacement parts come with installation instructions?

Top latch won't release to unlock door. Would like to replace it all.

The lock on our sliding glass door is broken. Name on the inside of the handle is Sash Controls of Ferndale MI. No other part numbers are on the handle. Patent #'s listed: 5820.170 6264.252 5125703 D340,398

Mine is closer to 9.75" at the screw fastener compared to this 11" Can you help? I found you guys from the two patent #'s

I received my new lock, it seems like it should be the one, however; the face plate I had previously didn't have a lock release button and this one does. Do you sell the face plate for the 82-239?

Hi i have door Guadian geneva , NY ANSI z97.1-2009 15 CFR 1201 II Safety tempered Socc 2259 1/8 UA CAM /0008-121-M I need the same mechanism for the lock Same in the picture

I believe this is the same part, However; the only measurement that doesn't match is the actuator hole. Mine seems to be 4 1/4 instead of 4 3/4.

I haven't removed this mortise lock yet, but based on these two photos, do you think the product MULTI-POINT MORTISE LOCK WITH FACE PLATE, 11"Product Code: 82-265 may be the right part?I can take more photos when I have removed it from the door.Thanks,Richard

No info available on lock

looking for mortise double acting lock