Viewing all customer Discussions for:

26-369 Flared Pivot Bar

Please review the image abovetop sash pivot bar 2 -5\16"

Need two vertical bars for my lower sash balance. Length 2-7/8", width 1/4", depth 1/8".

Folks,we bought a house with 20 year old replacement windows. The original installer was Bristol Aluminum from Bristol, RI. They claim they have no replacement parts for the windows that were made in Smithfield, Rhode Island, by Riverdale windows and Door. The installer was less than helpful.... ... (cont.)

Hi, I am in need of these clips. The ones you sell are similar however the tip sticking out needs to slide into a track like area where the counterbalanace is located. I also am looking for Pivot bars that look like your 26-369 without the flair part. The flair type is on the upper sash of these dou ... (cont.)

Farley 60DV2844 vinyl windows the tilt pieces have broken off

The part that fits into the shoe allowing the window to tilt. It is plastic and has broken off. Can it be replaced?

I found this part on your site part # 26-412 but mine is 1 inch and 3/4..... See attached ...do you have anything or do I have to cut it.

Looking for 2 pivot bars a little bit over an inch or so to match the above ones I sent in this email. It looks as a small part was broken off. The window is from the seventies and the window cavity seems not to hold much over an inch.

I have a broken pivot bar and I think it's a 26-369. There is a 72 in the circle closes to screw hole. Is that an identifier? I won't be taking the sash out until I have someone here to help me out incase I cannot get it back in the fame. So the remaining part is still in the sash. Can you still hel ... (cont.)

4 bottom guides straight (LIC PAT 5,069,001) 1 Sash top cover 1 bottom 90° guide 6 Sash locks internal with springs

I am looking for FLARED PIVOT BARS for my windows. Can you please help me get the correct part to fix. I think its about 5/16 or 3/16ths by 2 1/2.Has 2 holes. Please check and let me know, Thank you, Tina

I need like 5 of this hardware for my windows

Could you help me to find these parts? I need 4 for each of these parts to fix my windows.

the top window falls down freely without it. All the weight of the window comes down from the above window.

Broken window pivot

Hello, I am hoping to replace a 2001 Concord Double Hung window pivot bar. Pics of the window label and broken pivot bar attached. Not sure if the picture is clear enough to read the numbers on the bar. The top # is 1582 and the bottom # is 4110. I look forward to your response.

Can you tell me wjat part to order

The part is metal. It has no markings on it. Looks like the piece that rides the sash up and down jambhardware

I'm looking for this replacement part for a superior double hung window

The pin is in the sash and is slotted in the rail. There may be 2 pins