Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

21 inch on cabinet 19 1/2 inch on drawer

Kitchen Drawer Bracket broke. Trying to identify a replacement. See a marking of a G and number 6600 on part. When browsing your site, it appear that maybe this part could work (Product Code: 32-119) as a replacement, could you please advice if this may be a good replacement? Thank you! ... (cont.)

Hello. The attached photo is of a broken plastic piece used to hold the left slide in the rear. Can you identify it? Thanks

grant 236. 22 inches long. left side

Need attachment for sliding shelve tray Merillat cabinets

Looking for a right rear back bracket for a drawer/shelf slider. This is the piece that presses into place to accept the right slider of the drawer. - No part number or brand on part - Plastic/Nylon - Presses into existing holes in the back of the cabinet

Home was built in 2004, this was when the drawers were installed.

As seen in pictures maily need the end piece that holds the rails in olace if possible or if part of a kit. Probably could use half a dozen if could get. Please advise part number and or how to order. Thank you very much

The part broke and trying to replace this piece

Hello, this is the left side of the part I need. I need the same bracket or one that will work for the right.

We have a bracket that slides into the metal track and is pushed into a piece at the back wall of the cabinet. The piece that the metal bar slides into cracked. How do we remove the piece that is at the back of the cabinet. ours are very very tightly glued to the back wall. The cabinets we have ... (cont.)

Trying to indentify these as I need 8 to 10 of them. They are about 3" long (each way). They could be 2 5/8" ??? Not sure as I do not have it in front of me. But 3" is probably too long. & I Was told that they think Swisco was the original maker of these by the local lumberyard that actually ins ... (cont.)

We have a 15 year old Mastercraft kitchen drawer that has it's rail parts worn out. Need a new set. The longest rail part is 23 1/16".

Looking for replacement parts

I have Unigrass 6600 drawer slides on drawers of 18 year old kitchen cabinets. The bracket attached to the rear of the cabinet has cracked. What replacement part would work for this? I have a feeling there will be more. Thanks!

I need a mounting bracket with a 3/8" peg for insertion into a drilled hole in the cabinet rear panel. The rail is nominal 1" x 3/8" x 22.5" and is stamped with the logo G*. The manufacturer is Grass. My cabinet was installed new in 1986 when my house was built.

Maybe 20 years old. Socket type. See photo. Thanks.

Please help us to find relacement for plastic piece that holds drawer bracket.

My drawer tracks are UniGrass 6600 series. I have several with broken back plates as pictured. What back plate replaces the old ones?

I'm writing for recommendations of a replacement drawer slide. The original is a G.Grass that was installed with the house 25 years ago and seems to no longer exist. The original track length is 22" the drawer length is 21 1/16" Drawer height is 4", drawer opening is 4.5" tall Drawer width is 26 1/4 ... (cont.)