Viewing all customer Discussions for:

39-536 Truth Hardware Pivot Slide Assembly

Have 2 bathroom crank out windows that will open with no problem but when closing they will stop with a couple inches left before completely closed and the crank will just turn as if stripped. Not sure what part may be needed to fix. I have enclosed a photo of what the arms look like but not sure ... (cont.)

The operator is grey metal and has a marking that looks like with a triangle overtop of a line on it. The operator spline piece is on the left side. There is a number on it, but it is extreamly hard to read, the best I can tell it sais ?198?420 best guess maybe a 4 and 7 respectively for the ?. The ... (cont.)

31878 is number on piece. Guides window open and closed.

Is this piece sold separately? I need two

Looking for a replacement of these two.

Looking for this I believe it to be possible epi window

Need the plastic and metal parts that attach arms to window chanel.No numbers or marking on hardware that I could find.These are the parts needed.As you can see they are no longer useable.

ply-gem crank awning window need bottom awning black pivot clips - 700 series thank you for your prompt response jim

Please advise where I can purchase the hinge for the window. Thank you

Looking for replacement hardware as shown in photo.. this plastic part fits into each end of the crank mechanism within the loops.

I need the clip shown on IMG 4500 and the slider shown on IMG 4498. They are parts of the window opening mechanism on a Lowen window installed in 2017.The clip attaches the slider to the opening mechanism. The slider movers up and down in a channel screwed to the window frame. These are part of the ... (cont.)

Part 39 - 140 16 1/8" dual crank; accessory pieces/clips Looking for the clips/brackets depicted in the picture that will connect and guide the cranks arms onto the window frame

the black clip is it the same one u sell

Milguard Awning Window 34"x 34", it's the glide that fits in the bottom channel which fits into the hand crank, right and left sideAttached are 2 photos taken of the part I need to replace. I will need (6) of these parts.Thanks for help!Paul

I think this part will replace a broken slider on my vinyl awning window. Measurements match the broken part. However, I need to know how wide the track is. My part is 1/2 wide which slides in a track. I assume there is a clip that goes on the knob the goes in the hole on the crank arm. I hope ... (cont.)

I need the bracket or piece that attaches to the bottom of the window were the pin connects to it. I think it may be a snap clip plate or something. Thanks

Hi Paul...I live in Hawaii..have about 24 awning windows installed 2001...from lack of use and salt conditions..the cranks do not open and I have broken many of your slide connectors...39-536.....by relaxing broken clips 39-536 can I make it work...what spay lubricant would you use to loosen and ... (cont.)

The pic attached is of a a clip that goes on the arms that extend out in crank out window. It attaches and slides along bottom of window as it's being opened. The clip in the pic is broken into two pieces but I'm sure you're familiar with it's function and how it looks attached together. Thanks ... (cont.)

the 1 x 1 black latch (clip on) to attach window to opening bars for Alside window

can i get some of these? they are for a sissor crank