Viewing all customer Discussions for:

82-249 Sliding Glass Door Multi-Point Keeper

The handle with the lock is loose because the socket for the screw snapped. The Screw Holes are 3 15/16" apart. Do you have a Chrome or Brass set that will fit. No idea who manufactured the doors or hardware.

Hi if you don't mind I need help deciding which Keeper that works with my current pull/lock handle. Thanks kindly.

Good Evening - First, thanks for your helpful videos and postings on door hardware. Second, I have a broken patio door lock latch. (Fortunately it is broken in the locked position.) The attached pictures seem to match an 82-089 handle system. The problem is, I need only a bronze latch lever and ... (cont.)

Mortise patio door lock , keyed, JW , chassis PAT# 6.264.252 , PAT # 5.820.170 , inside trim PAT D466787, outside trim PAT # D466787 Sash controls Canton SD Made in June 2010 in Taywan , Amesburry door hardware, Sioux Falls , SD

Will this keeper work for lock number 82-265

My lock broke. Can you help me get the right part please.

I need to find a multi-point strike that is 10 3/4" long x 5/8" wide x 1/2" deep.

Looking for replacement sliding glass patio door jamb catchs

The latching mechanism on my patio door locks easily but frequently it is very difficult to unlock. We installed the door a number of years ago and I have no idea what brand door it is. The handle is approximately 13" long and maybe and inch to 1.5" wide. Thanks

The door lock is worn out wont unlock and the latches seem not to clear the jam side. I need a replacement mechanism

I'm looking for the receiver (female) portion for a door latch from a Superior brand patio slider. I just need the receiver - the handle and latch is fine. Thank you.

I recently moved into a home with a patio door that did not have a mortise lock in place. I believe I need a multi-point mortise lock similar to part 82-265 but wanted to confirm. I'm attaching a few photos I took to make sure this lock will work. There is a keeper installed but I'm not sure if I ne ... (cont.)

IMG_1068 - 3.5" between screws IMG_1069 - outside screws 11", inside screws 4" IMG_1070 - 4" between screws IMG_1072 - 4" between screws

We got this patio door from another party and is missing what holds the stationary door in place, which we don't know what that is, missing the handle inside and out, missing the other half of the lock mechanism. The only marking is in the glass which says ppg herculite k.The size of the locking mec ... (cont.)

This may be from a Harvey sliding door. According to the measurements it looks like it may match up to a 82-249 keeper. There is a patent number on the lock that is 5820.170. Would like to know if you think this keeper is the one to order. Thanks

I need the entire lockset. Handle, mechanism, latch. Not sure who manufactured the door. It's a double wheel latch. Whole assembly is between 10 and 11 inches.

Can you suggest replacement for these two patio door latches? One snapped/broke off, the other is still working - so would need to replace both so they match (in the same room). These are "generic" doors - not Anderson or Pella - not sure of the original manufacturer.

One side is broken

Looking for the strike plate for this Pelli door lock? Jerry

Hello looking for a replacement for this door