Viewing all customer Discussions for:

70-219 5 Pack, Snap-On Plunger Pin Assemblies

I need at least 30 of these---- they hold the screen in the window frame

Hello, Looking to identify a replacement option for this plunger pin. My house is 20 years old and I assume all these pins were original to the house- and because they're plastic about 90% of them are broken so I've been forced to used double sided tape as an alternative. Maybe there is a more stur ... (cont.)

We have Traco windows the interior screes have plastic pins to take the screens in & out. But many of them are broken. How do I get replacement parts?

The pin is 1 3/4" in length, and is made of plastic. The window was installed circa 6 years ago. On the window it says: CIG6 15 AWA 42804-4A11 NFRC 272 Integrity From Marvin.

Hello Really Helpful Person, Simple screen pins. I'm not really sure of the exact length because I only have broken pieces. They're from a window using TRUTH hardware if that helps. TIA Kevin

This is for a Marvin Window screen. House built 94-95. Have anything similar?

Looking to buy two new screens for my condo windows, just to update the look. They contain four "plunger pins" I believe they are called. (they pop in and out in order to remove the screen at any time) I would like to purchase 2 of these and 8 plunger pins. Any ideas? The window screens have this ... (cont.)

I need the pins for the screens as well as the corners for the screens. I also need the seal for the bottom of the window. I hope this helps us figure out what we need from you.

These are from a 2015 installation of All Ultrex (I believe now they are banded Marvin Integrity) single hung windows. The pins in some of the windows broke and some do not have the springs. I would like about 10 pins to replace broken ones and have on hand for future use.

I have Marvin infinity windows installed in 2007. The plastic pins holding the screen are becoming brittle and breaking off. They are translucent white plastic with a spring. About 42 mm in length with the end piece pushed in. The diameter of the smaller end is around 3 mm.

Your plunger pin 70-219 shows 7.32" diameter but the width of my screen is only 5/16" and the existing hole is only 1/8". Do you have a plunger pin that will fit this screen? Only one plunger pin is missing and the other pins are about 1 1/16" long, which means 3/4" of the pin is in the screen and ... (cont.)

Need to get replacement for the pins. Look to be about 2/16' diameter and 1' length. Some pin heads broke off, some are just jammed.

I ordered #70-219 they are to short These screen are off of MArvin Windows Can you figure out the correct part number? thanks Mike

Hello, Please help me find the right screen insert pin. Picture is attached. Thank you, S

I need to buy replacement plunger pins for a screen part #A-X7164. Thanks

I would like to order and replace several screen tabs for my integrity screens. Please see attached photos and let me know how I can order them and/or what parts number I should use

Plastic pin: what?s the length of the pin please mine as others have stated looks more like a screw but is plastic thanks

Need plug for screen storm door. Part looks like a screw but has no threads. Part holds large spring to door frame. Can I purchase two?

Do you carry the pin that holds the screen in place? If so what is the cost?

I'm looking for screen retainer pins. Have you got anything like this