Viewing all customer Discussions for:

26-116 Window Sash Lift Handle

Driftwood in color described as Peachtree Sash Lift kit

Good Morning, About 8 years ago we had a sun-room addition built and the contractor installed Silverline 3000-3900 windows. Unfortunately the top window on all the windows have cheep plastic lifts on both the left and right side of the window. Over time many of these have broke - as we have tri ... (cont.)

I bought windows in 1988. I guess made by Winchester. I have taken other pieces from window. Have anything like this? Had a model # on window of 755.00

There are some small differences in measurements with 26-310 if you don't find the exact same one, please get me the closest one that has mainly the pin measurement that fits in to the window track connection. Thanks so much

Measurements 3 1/4" L and NOT INCLUDING THE LOCKING PROTRUDING OART 1 1/4"wide Scew holes (2) are set 2 1/2" apart -center to center As Can see from the pic the screw hole WHIXH Doesnt house the protruding locking part sits very close to end of the part The 2nd screw hole sits on. Enter ... (cont.)

Hello, I'm looking for replacements for window handles. We recently purchased a condo from the 60s that seems to have old handles and nobody carries a similar size. There are 2 handles on each window and the windows slide sideways to open them. The holes are about 2 1/4 inches apart, which is the pr ... (cont.)

I have 3 pieces to order replacement parts for. I need 6 white locks. 4 white clips and 20 grips or handles Are you able to identify the parts from the pictures?

I need help finding this part. I have several windows where this is broken

From sliding window, might be American Crafsman? Width 3/4" length is 4" screw hole center to center 3 3/4". Got anything like this? Thanks

Not sure window brand. House builder in 1996. Not sure how old is this window.

Handle to pull window shut

These are 2 inches center to center. It is 1/8 inch thick.

The picture is all I have to go by.

Each window has these 4" handles. I can't seem to find them. Can you help me? Thank you Tony

these are on a rental home so these are the best pictures i took, they measured 9/16 thick I have 15-118 in my cart, is that correct or would you suggest others? i don't mind buyin 2 versions and returning the wrong ones just would like to have the right supplies when i go to repair these windows ... (cont.)

The part is approximately three inches long. The windows were installed around 25 years ago. The brand name of the windows, I believe, is Bristol. The breakage occurred when large children used the lifts to close the window.

No identification marks Anything close I will open too.

no markings or brand on any windows-house is in Naugatuck,Ct.

Looking for a window sash pull with 3 1/2 in hole centers. All I can find are 3 5/16 center holes. Can you help?

I have been searching for a sash pull without screws for the new Marvin Wood inside / fiberglass outside windows that came without sash pulls. Marvin says we can not drill the window as it may break glass and will void the warranty. Sales neglected to tell me no sash pulls. I have noticed your 26 ... (cont.)