Viewing all customer Discussions for:

90-278 Lock & Keeper, 2-1/16"

Looking for locking latch and keeper similar to those shown in photos. Mounting holes are 2" on center. Dimension from edge of latch (flush with window) to mounting holes is 5/8". (The tape measure in the one photo is actually measuring 2", but because of the angle of the lens, it looks like less; ... (cont.)

Looking for spells window latch

Hi there, Please advise good match.

I have the original locks like these and the white metal laches keep breaking. ARE YOUR LOCKS MADE FROM WHITE METAL OR PRESSED STEEL. I f I do not have the lash completly pull back they snap off.

Broken Tab on Keeper - needs replacement part OR Replace combo: KEEPER & LOCK Keeper is stamped with 4 letter/number combo (MY BEST GUESS) Sash Lock is stamped 9311 A-S PA 92 08 - (MY BEST GUESS)

Have 3 epi window locks I need to replace

ACAN WINDOWS have gone out of business. In my locking bracket, the little flat bars that put tension on the pivoting locking latch are coming out. Do you know how to eliminate this or do you know where I can get replacement brackets from? The lower bracket ( company name ) Middle bracket ( flat ... (cont.)

I need three locks for windows in a house built around 1998. I've just sold the house, and agreed to replace the broken locks for the buyer, not realizing that this would be an ordeal. My contractor tried some locally available replacement locks, but no luck. He says the main locking piece (phot ... (cont.)

i have been using the 90-238 for replacing viking latches, but it seems you discontinued them. will the 90-278 substitute for that latch?

Looking for Sash Lock & Keeper for Sliding Windows

Single hung window lock is broken. The latch handle is snapped off. I can not find any markings on this window anywhere to find the manufacturer.

Is this product metal or plastic?

Hello, My name Octavio and I am looking for vertical window locking hardware. I believe the one that I need is part number: 90-278.

I need a couple dozen of these latches for my hotel. The holes are on 2" centers. I have more pictures if needed.

Champion sliding window latch

Good day, I had some trouble uploading the pictures attached. They are for the American Craftsman 2110 series. The other window parts are for the 7550 Casement. I need the full set of parts for that window as they have rusted severely. THanks in advance. Clyde R.

do you have a replacement part that might replace a missing Viking latch?

I have 31 wide x 72 high double hung windows with a single sash lock similar to your 90-278. The single lock is worn and not strong enough to hold the top sash all the way up, resulting in a gap at the top allowing air to seep through. I would like to put two sash locks on each window to provid ... (cont.)

Attached are photos of the part installed and removed (on 1/10" graph paper). The only marking is a "MDC 5" stamped inside the outline of Texas. The lock screw holes are 2-1/16" apart, like several of your locks, and the lock is 2-13/16" long and 1-5/16" from front to back. The keeper is 2-1/4 ... (cont.)

champion window color: beige inner markings: ADH 8B-03-1 approx specs: ht--2 1/16" (center hole to center hole) width: 14/16" (center hole to center hole)