Viewing all customer Discussions for:

79-030 Weatherstripped Faceplate, Long Throw

Hi, I am looking for the face plate in my photo in white, it measures 6-7/8 in long x 1-1/8 in Wide The two bottom holes are 2 inch center to Center Throwplate opening is 2.3 inch The Top single Screw Hole is .5 inch from the edge between the top and the throw plate opening Do you have this it ... (cont.)

Looking for the correct part to fill this gap that is in the lock area

Commercial doors need new weather stripping. Please advise Tx

Looking to replace this Faceplate which has weatherstripping please

Looking for an astragal weatherstripping similar to 58-085 but with a pile projection of 1/2"

Commercial aluminum storefront door felt weatherstripping 1/2" x 11/16"

Didn't find any numbers or markings on the weatherstripping or the door

need to order 1 1/8 " wide. (Aluminum; Face Plate w/ weatherstripping) need quote with ETA and total cost

Hello I need weatherstripping for this commercial door including the piece around the latch. Is this something you can help me with? Top piece is 31 1/4" and bottom is 45" plus the assembly around the latch. Thanks!

The entrance door weatherstripping is need of replacement. 8' long 1/2"x7/16 and mortise lock double mohair.

I purchased the weather strips for our two entry doors from you and now I need the weather stops for around the two locks. Can you point me to the correct part number?ThanksJoe

We have a Kawneer door that I thought part 79-030 would fit, but it does not quite. 1.Your part is 1" wide, the Kawneer is 1 1/8". Your part would leave a slight gap on one side, allowing rain to enter the door unless sealed somehow. 2.Your part is 1/16" longer (it could be filed down, if that was ... (cont.)

Could you please give me some advice. I just bought an old building that's been neglected. 3 doors. all metal standard size. all exterior doors. The front doors has the only professional insulation on one side. Took a sample (like you side in the video) 1/2" wide, 1/2" thick pile. Lots missing. Can ... (cont.)

Need help with the kind of sticker plate s that I have pictures for

Hello, I have a commercial door that needs to have the lock plate with the embedded weatherstripping replaced. It appears that the felt weatherstripping is embedded into the plate and it cannot be slid out and replaced as I had hoped. I have added the dimensions of the plate and it's opening along ... (cont.)

I have to replace the door weatherstripping ( 58-085) but we recently had push bars installed on the church front doors and they replaced the existing deadbolt and now we have this blank faceplate. the faceplate measures 6 3/4" tall by 1 1/8" wide . do you carry anything that would weatherstrip this ... (cont.)

Can you help with figuring out which gasket to order. The gap between the two doors is 9/32 and the plastic slide on the current seal is .37. The door is 84" in height. I am not sure how to replaced the gasket around the locking mechanism.

We don't have the manufacturer.There is a small piece missing. It probably just slid out of the slot since there is a 2 inch gap where the door lock is and it might have slid out there.It looks like a total of 1.5 inches wide with the aluminum holder and 3/4" for the bristle part. ... (cont.)

which ones will work? How do I know if it's short or long faceplate? Which doorsteps will work?

Do you have the weather stripping that works with this style commercial metal door? We have replaced the upper and lower weather stripping but still need replacement at the lock area. Thank you for your assistance.