Viewing all customer Discussions for:

90-282 Recessed Keeper

searching for a couple of window latches for Jeld-Wen double hung windows installed in 2005.. marking on corner of windows: CO305229380207 NW C/C 3-2-05 LO E

Unsure if these are swisco parts but they looks similar.

It appears that Product Code: 90-278 will work for my needs. The windows are Acorn sliders with an 2 1/16" screw spacing and an 11/16" backset. I ordered another latch online that met these parameters but the locking cam was much wider and required much more of the cam to be engaged in the keeper t ... (cont.)

Has a number 9906 on part. Don't know the name brand of the windows

Hello I'm looking for a replacement for this product I believe the whole distance is 2 1/16 this is for a left to right sliding window vertical sash

we need the keepers as per the 1 st photo, the second photo is for referece

Need replacement for broken clutch.

I'm awaiting a photo of the other sash channel to determine if the clip receiver pictured is damaged. In the meantime, will you please identify this part?Nathan

Hi! I'm not the original poster but I'm also looking for a replacement of this part. I've attached a photo, the tongue is roughly 3/8s of an inch high and 3/4 of an inch wide. The screws you can see are 2 & 1/4 inches apart, the broken latch still has screws that are tricky to access/measure, but se ... (cont.)

I am looking for this latch replacement

Looking for the keeper for Flush Mount Lock, 1-11/16" Product Code: 90-281 Best, Yraklis

Looking for a replacement for a Pozzi double hung window lock. The window was installed in 1991.

We have a broken EPI window lock. My wife had ordered the 90-278 replacement latch, which fits the existing holes. The problem is that the keeper is recessed in the indention between the window panes and the latch can't access the attachment point. Looking at existing EPI keepers, the attachment po ... (cont.)

Don't know how to determine model of window, but hopefully someone can tell what i need from the images provided. Thank you in advance

Looking to replace this latch.Thank you Gene

This part is where the latch of the lock slides into. Part is broken in this photo. It is 3" long and screw holes are 2 1/2" apart.

Don't have any Identifying marks. Haven't been able to take them off to inspect. Latch must work at 90 degrees. (Right angle). I've seen many of these on Mirage screen doors, but Mirage says they don't have them.

I'm looking for four sash locks for my vinyl Viking windows. The sash lock is 2 ¾" by about 1 ¼". I have attached a photo. Please note that the "receiver" is very thin. (I purchased a replacement part on Amazon, but the "receiver" was too thick, which prevented the window from opening. ... (cont.)

We have been trying to find these window latches to replace on a couple of our windows because they have broken. I have attached pictures of the latch. If you happen to have them or know where I can get them, please let me know! I don't see any brand or markings on the windows or latch to even fin ... (cont.)

This is a window latch with a very very thing part to hook into. The original is a Viking Latch and the part that the latch hooks into is VERY thin and the window slides over it. Per the photos, I think the part that the latch hooks onto is just 3/16" of an inch wide. I need to locate this assembl ... (cont.)