Viewing all customer Discussions for:

39-107FK Truth Folding Handle And Cover Kit

Looking to see if you guys have any of these window cranks available. If you do, you can also contact me at 805-332-4477 thank you

Window crank needed #39-031

Hello, I am in need of the missing crank and plastic cover (that are circled in the first picture). The window that it's missing on is in the second picture. I borrowed the crank I have on the other window and it works fine- it's just missing, as is the cover. I also included the only sticker/mar ... (cont.)

The handle for the casement window keeps falling off, and the stud that it goes onto appears worn. Also the plastic cover over the mechanism is cracked. This is the mechanism for a Marvin wood-framed casement window. Inside the cracked cover is the word "Truth." I think I need a new crank handle, a ... (cont.)

I am looking for a replacement crank for a Lincoln casement window

I have a Marvin casement window w/ 40574 stamped and the arm is approx 8-3/4" long (from center of nylon bushing to center screw hole aligned with the crank). From center of nylon bushing to end of crank is roughly 11-1/2" See photos for more info. Can you pls tell me part # and/or link to Swisco. ... (cont.)

U.S. PAT. 4,241,541

Can you help? Do you have thses

Hello, I have an older crank window and below cover broke probably due to age. Any idea what part I need to order or if you need more info from me? Thank you - Marc

Looking to replace the crank and window latches. It says "truth hardware." My guess is this is 15 year old window. No other markings. We have Andersen E series windows everywhere else. See if there is any option in more of an antique bronze color.

Need left hand (viewed from outside) sash hinges - pretty sure these are 10" 2-bar but want to verify. they say Truth EntryGard on them. Your P/N 36-048? I want to replace both upper and lower. Please confirm... one source says a lipped casement window requires a 4-bar but doesn't look the same as ... (cont.)

I need one like this for the left side

Looking for advice on my casement window. I have several window that open easily but cannot be closed, especially the last inches of two before they close and are latched.

Kolbe pre-2006.

Please, help me identify the mechanism, sosthat I can do the repair.Thank you,Lev

Hello,I have two Crestline crankout windows that are faulty. They will crank open, but will not close. I have located part numbers on the "assembly". One has identifying marks saying EntryGard Truth 20810 and the other has EntryGard Truth 20810A. Each cranks opposite directions (left hand and right ... (cont.)

truth casement window long arm: 8.5"- 8.75" (still installed, difficult to get an arm-to-center measurement)short arm: slightly less than 4"hinge: 10"-11" (difficult to be exact with the rust)

Hi. This is a truth crank mechanism. Which is the correct cover and crank? Thank you for your help.

I need to replace the window cranks on several of the casement windows in my home. I hope the photos attached give you enough info. to know what I need to buy.

I'm not familiar with windows. Is this apparatus the only thing that holds the window on the bottom? When remove it I assume I need the window closed and locked - correct?