Viewing all customer Discussions for:

39-107FK Truth Folding Handle And Cover Kit

Need left hand (viewed from outside) sash hinges - pretty sure these are 10" 2-bar but want to verify. they say Truth EntryGard on them. Your P/N 36-048? I want to replace both upper and lower. Please confirm... one source says a lipped casement window requires a 4-bar but doesn't look the same as ... (cont.)

I need one like this for the left side

Looking for advice on my casement window. I have several window that open easily but cannot be closed, especially the last inches of two before they close and are latched.

Kolbe pre-2006.

Please, help me identify the mechanism, sosthat I can do the repair.Thank you,Lev

Hello,I have two Crestline crankout windows that are faulty. They will crank open, but will not close. I have located part numbers on the "assembly". One has identifying marks saying EntryGard Truth 20810 and the other has EntryGard Truth 20810A. Each cranks opposite directions (left hand and right ... (cont.)

truth casement window long arm: 8.5"- 8.75" (still installed, difficult to get an arm-to-center measurement)short arm: slightly less than 4"hinge: 10"-11" (difficult to be exact with the rust)

Hi. This is a truth crank mechanism. Which is the correct cover and crank? Thank you for your help.

I need to replace the window cranks on several of the casement windows in my home. I hope the photos attached give you enough info. to know what I need to buy.

I'm not familiar with windows. Is this apparatus the only thing that holds the window on the bottom? When remove it I assume I need the window closed and locked - correct?

Left and right I need the complete assembly

I have an older crestline installed window. The crank is no longer working - can't open or close the window. It has a pin that should go in to line up with the gears so the crank will do it's work but I cannot get that back in to its correct place. I am wondering if I should just try to get a new cr ... (cont.)

Only marks = Made in USAJust need the housing/crank not the window hardware (already installed) (Painters removed and then lost them!)

I have one bar (arm) Truth hinges with the number 40942-A stamped on the bottom hinge. I'm assuming these are no longer being made (they are on 25+ years old Marvin windows). Does the 2 arm- Right Hand (Standard) Casement Window Hinge Assembled 10" replace the old one arm 40942-A. Will I need a ... (cont.)

Which operator do I need? Casement window is 27" wide. Short arm 4 7/16" Left handed. Is it returnable if the repair man to fix broken glass has an operator in stock?

I have Loewen windows that were installed 2001 or so.Screen pins.Awning window cranking mechanism.

Hi, Can I replace stem. handle and cover, or comleete mechanism for this RT side casement window?

I would like to purchase replacement window operators for casement windows. On the back of the long arm there is the number S-1081-102 On the curved part of the short arm there is the number S-1081-03 On the straight part of the short arm there is the number S-1081-66 On the back of the plasti ... (cont.)

Need replacing them. Windows will open but not close.

Hi, I need to replace the left and right side, could you please tell me what do I need to order. Thank you